Isuzu Rodeo UE. Service manual — part 82
4C–37
DRIVE SHAFT SYSTEM
401RW018
7. Install snap ring.
Reassembly
401RW032
Legend
(1) Sleeve Yoke
(2) Clamp
(3) Boot
(4) Clamp
(5) Tube Assembly
4C–38
DRIVE SHAFT SYSTEM
1. Apply grease evenly to both the female and male
splines.
2. Apply a small amount of grease by finger to the outer
lips of the boot.
3. Slide the boot onto the yoke shaft being careful not to
damage the spline coating or boot.
4. Insert the yoke shaft spline into the sleeve being
careful to maintain proper phasing. The spider holes
should be in line and as per originally marked prior to
disassembly.
5. Position boot onto sleeve and yoke shaft in final
position over boot grooves.
6. Attach boot clamps and secure using pliers.
7. Be sure clamp is properly seated and secure.
Main Data and Specifications
General Specifications
Transmission
M/T
A/T
Length (between two spiders
center)
367.2 mm (14.81 in)
542.2 mm (21.35 in)
Torque Specifications
401RX001
4C–39
DRIVE SHAFT SYSTEM
Rear Propeller Shaft
Rear Propeller Shaft and Associated Parts
401RX003
Legend
(1) Bolt, Nut and Washer (Transfer Side)
(2) Rear Propeller Shaft
(3) Bolt, Nut and Washer (Rear Axle Side)
Removal
1. Raise the vehicle on a hoist.
NOTE: Apply alignment marks on the flange at the rear
propeller shaft both front and rear side.
2. Remove transfer side bolt, nut and washer (except
spline yoke type).
3. Remove rear axle side bolt, nut and washer.
4. Remove rear propeller shaft.
NOTE: Plug the hole of the transmission rear end to
prevent oil leakage (spline yoke type only).
Installation
NOTE: Never install the shaft assembly backwards.
Never insert bar between yoke lugs when tightening or re-
moving bolts.
Completely remove the dust or foreign matter from the
connecting surface of flange coupling on each end of the
propeller shaft.
1. Align the mark which is applied at removal.
2. Install rear propeller shaft and tighten the bolts to the
specified torque.
Torque: 63 N·m(46 lb ft)
4C–40
DRIVE SHAFT SYSTEM
Slip Joint Disassembly
401RX004
Legend
(1) Spline Yoke and Universal Joint Assembly
(2) Clamp
(3) Boot
(4) Clamp
(5) Tube and Universal Joint Assembly
1. Lay the shaft horizontally on a bench and secure.
2. Indicate the original assembled position by marking
the phasing of the shaft prior to disassembly.
3. Using the flat blade of a screwdriver, pry the loose end
of the boot clamp upwards and away from the
propeller shaft boot. Be careful not to damage the
boot.
4. When boot clamps becomes loose, remove by hand.
5. Repeat for the other boot clamp.
6. Remove the slip yoke assembly from the driveshaft,
by securing the boot with one hand and pulling on the
slip yoke.
7. Remove the boot from the shaft assembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст