Isuzu Rodeo UE. Service manual — part 609
8F–9
BODY STRUCTURE
Removal
1. Open the hood.
2. Support the hood.
3. Remove windshield washer nozzle tube.
4. Remove hood hinge bolts.
f
Before removing the hinges from the engine hood,
scribe a mark showing location of the hinges to
facilitate installation in the original position.
610RS006
5. Remove engine hood.
6. Remove radiator grille.
f
Raise the clips on the radiator grille.
603RS006
7. Remove front combination lamp assembly.
f
Disconnect fixing screw and connector.
801RW027
8. Remove inner liner fixing screws and remove inner
liner.
647RS001
9. Remove instrument panel driver and passenger
lower covers.
10. Disconnect antenna cable.
8F–10
BODY STRUCTURE
11. Remove front fender panel.
f
Disconnect 8 fixing bolts.
614RX001
Installation
To install, follow the removal steps in the reverse order
noting the following points:
1. Tighten the front fender panel fixing bolts to the
specified torque.
Torque : 6.5 N·m (56 lb in)
2. Tighten the engine hood fixing bolts to the specified
torque.
Torque : 9.8 N·m (85 lb in)
3. Adjust the clearance between the each of the panels.
610RW005
f
Check the fender and front door (3).
Clearance : 5.0 mm (0.196 in)
Height (step) : Flush
f
Check the front door and rear door (2).
Clearance : 6.0 mm (0.23 in)
Height (step) : Flush
f
Check the rear door and body (1).
Clearance : 5.0 mm (0.196 in)
Height (step) : Flush
Adjust clearance with door hinges.
Adjust height (step) by tapping on the fender lightly
with a rubber hammer.
610RW001
8F–11
BODY STRUCTURE
f
Check the engine hood and fender (4).
Clearance : 4.5 mm (0.18 in)
Height (step) : 0.5 mm (0.02 in)
Adjust clearance with the hinges on the engine hood.
Adjust height (step) with the hood rests (5).
610RX001
610RW004
8F–12
BODY STRUCTURE
Body Dimension
Front Section
A10RW034
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст