Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Service manual — part 968
4C1-42 FRONT WHEEL DRIVE
Important Operations
Before removal, jack up the front of vehicle and support frame
with jack stands.
2. Brake Caliper
(1) Remove the two bolts from the rear side of the knuckle arm,
then remove the brake caliper, with the brake hose
attached.
(2) Use a wire etc., for attaching the brake caliper to the upper
link.
3. Hub Cap
When removing hub cap, exercise care so as not to scratch or
distort hub fitting face.
9. Hub and Disc Assembly
Using a brass bar to remove the outer bearing outer race (1),
oil seal, inner bearing and inner bearing outer race (2) from the
hug.
If necessary, replace the wheel pin in the following manner.
12.Bolt
13.Wheel Pin ; Front Hub
(1) Scribe mark on hub to disc before disassembly to insure
proper assembly.
FRONT WHEEL DRIVE 4C1-43
(2) Clamp hub and disc assembly in vise using protective pads
and remove six (6) disc to hub retaining bolts.
(3) Place hub on a suitable work surface and remove wheel
studs, as required, using a hammer.
4C1-44 FRONT WHEEL DRIVE
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage or any other abnormal conditions are found
through inspection.
•
Hub
•
Hub bearing
•
Bearing outer race
•
Disc
•
Oil seal
Visual Check
Check the following parts for wear, damage or other abnormal
conditions.
FRONT WHEEL DRIVE 4C1-45
REASSEMBLY
Refer to SECTION 3E “WHEEL AND TIRE” for wheel removal procedure.
Reassembly Steps
▲
1. Wheel pin
▲
2. Bolt
▲
3. Inner bearing and outer race
▲
4. Oil seal
▲
5. Hub and disc assembly
6. Outer bearing
7. Lock washer
▲
8. Hub nut
9. Nut retainer
10. Split pin
▲
11. Hub cap
12. Brake caliper
▲
13. Bolt
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст