Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Service manual — part 1376
ELECTRICAL-BODY AND CHASSIS 8-69
3. License plate light does not light
Checkpoint
Trouble Cause
Countermeasure
Repair open circuit or
connector contact
Continuity between
connector 1
T-3
- 2
T-3
Open circuit or poor connector
contact
NG
Replace the bulb or repair
connector contact
License plate light bulb
continuity
Bulb burned out or poor
connector contact
NG
OK
4. Clearance light does not light
Replace the bulb or repair
connector contact
Clearance light bulb continuity
Bulb burned out or poor
connector contact
NG
5. Illumination controller does not operate
Repair knob installation or
replace the controller
Turn the illumination controller
knob (Brightness should
change)
Loose knob or faulty controller
NG
Repair short circuit or replace
the wire
Disconnect the illumination
controller connector (Light
should be dim)
Short circuit
NG
OK
8-70 ELECTRICAL-BODY AND CHASSIS
REMOVAL AND INSTALLATION
HEADLIGHT
Removal
1. Remove the radiator grille center bolt.
2. Use a screwdriver to raise the clip and release the lock.
Place a clean rag beneath the screwdriver tip to protect the
body painted surfaces.
3. Remove the radiator grille.
4. Remove the headlight rim.
5. Disconnect the headlight connector.
6. Remove the headlight.
ELECTRICAL-BODY AND CHASSIS 8-71
Installation
Follow the removal procedure in the reverse order to install the
headlight.
Pay close attention to the important points mentioned in the
following paragraphs.
Connector
Be absolutely sure that the headlight connector is securely
connected.
This will prevent a contact and an open circuit.
LIGHTING SWITCH
Removal
1. Remove the steering wheel
1
.
Refer to the “STEERING” Section of this manual.
2. Remove the Instrument panel lower cover
2
.
3. Remove the steering column cover
3
.
4. Disconnect the connector.
5. Remove the lighting switch from the steering shaft.
Installation
Follow the removal procedure in the reverse order to install the
lighting switch.
Pay close attention to the important points mentioned in the
following paragraphs.
8-72 ELECTRICAL-BODY AND CHASSIS
Connector
Be absolutely sure that the lighting switch connector is securely
connected.
This will prevent a poor contact and an open circuit.
Wire Harness
Do not pinch the wire harnesses between the cluster and the
meter hood during the cluster installation procedure.
Wire damage will result.
CLEARANCE LIGHT
Removal
1. Remove the radiator grille.
(Refer to headlight removal procedure.)
2. Remove the side screws.
3. Remove the top screw.
4. Turn the socket counterclockwise to disconnect it from the
clearance light housing.
5. Pull the bulb from the socket.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст