Isuzu D-Max / Isuzu Rodeo (TFR/TFS). Service manual — part 1506
8-124 ELECTRICAL-BODY AND CHASSIS
ILLUMINATION CONTROLLER
Turning the illumination controller knob upward increases the
brightness of each illumination light, turning it downward
decreases its brightness.
Removal
1. Instrument Panel Cluster Assembly
• Refer to Section 10 “BODY” for instrument panel cluster
assembly removal steps.
2. Illumination Controller
• Disconnect the switch connector.
• To remove the switch, push the lock from the back side
of the cluster assembly.
Installation
To install, follow the removal procedure in the reverse order.
Connector
Be absolutely sure that the illumination controller connector is
securely connected.
This will prevent a poor contact and an open circuit.
ELECTRICAL-BODY AND CHASSIS 8-125
AIMING OF HEADLIGHT
check and adjust the inflation pressures, clean the headlight,
park the vehicle on a level surface and insure that vehicle is at
curb weight.
VERTICAL ADJUSTMENT
Use a screwdriver for vertical adjustment.
HORIZONTAL ADJUSTMENT
Use a screwdriver horizontal adjustment.
8-126 ELECTRICAL-BODY AND CHASSIS
INSPECTION AND REPAIR
Switch side
LIGHTING SWITCH
Lighting Switch Connections
Terminal
SW
No.
position
1
7
8
OFF
Tail
Headlight
Switch side
HEADLIGHT BEAM SWITCH
Headlight Beam and Passing Switch
Connections
Terminal NO.
SW position
16
13
15
14
HI
LO
At “Passing” Position
At “Dimmer” position
ELECTRICAL-BODY AND CHASSIS 8-127
LIGHTING RELAY, TAIL RELAY
Check continuity between the relay terminals.
1
-
5
. . . . . . . No continuity
(When battery voltage is applied between
2
and
4
)
1
-
5
. . . . . . . Continuity
ILLUMINATION CONTROLLER
Controller Inspection
Check the illumination controller function.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст