Isuzu KB P190. Service manual — part 1371
8A-546 ELECTRICAL-BODY AND CHASSIS
Keyless entry control unit
RUW580SF000201
ELECTRICAL-BODY AND CHASSIS 8A-547
Pin-outs
RUW580SF000301
No. Pin
Function
1
Door ajar switch
2
Door ajar indicator light
3 Tailgate
switch
4
Test pin (Internal use only)
5
Key switch remote
6 Ignition
switch
7 Battery
8 Hazard
battery
9 Unlock
10 Lock
11
Front map light
12 Hazard-RH
13 Hazard-LH
14 Ground
8A-548 ELECTRICAL-BODY AND CHASSIS
ID Code New Registration
All registered ID codes shall be erased, and a new
received
ID code shall be registered instead of old codes.
Carefully read each of the steps before beginning the
operation.
Step Action
Yes
No
1
NOTE: Make sure that the all the doors are closed and
unlocked. Remove the ignition key from the ignition switch.
1. Open the driver's side door.
2. Insert the ignition key into the starter switch.
Is the action complete?
Go to Step 2
2
Turn the ignition switch to ON position and return it to OFF
position three times.
NOTE: This step must be carried out within five seconds.
Is the action complete?
Go to Step 3 Go
to
Step 1
3
Close and open the drive's side door twice.
NOTE: This step must be carried out within five seconds after
step 2 is finished.
Is the action complete?
Go to Step 4 Go
to
Step 1
4
1. Turn the ignition switch to ON position and return it to OFF
position twice.
NOTE: This step must be carried out within ten seconds after
step 3 is finished.
Is the action complete?
Go to Step 5 Go
to
Step 1
5
Operate the lock or unlock button of the transmitter.
NOTE: Confirm that the system is functioning by pressing the
transmitter button to lock and unlock the doors. Listen for the
sound of the actuator operation.
Is the action complete?
Go
to
Step 1
ELECTRICAL-BODY AND CHASSIS 8A-549
RUW59DMF000101
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст