Isuzu KB P190. Service manual — part 744
Engine Mechanical – V6
Page 6A1–199
Page 6A1–199
13
Remove the bolt (1) attaching left-hand intake
camshaft sprocket (2) and remove the sprocket.
Figure 6A1 – 325
Clean
1
Clean the exterior of each camshaft sprocket with solvent.
Safety glasses must be worn when using
compressed air.
2
Dry the timing components with compressed air.
Inspect
1
Inspect the front of each sprocket for the following:
•
Sprocket damage (1), and
•
Sprocket bolt seating inner hub damage (2).
Figure 6A1 – 326
Engine Mechanical – V6
Page 6A1–200
Page 6A1–200
2
Inspect the back of each sprocket for the following:
•
Sprocket damage (1),
•
Camshaft locating pin damage (2) and,
•
Camshaft seating/sealing inner hub flange
damage (3),
N O T E
These checks apply to both the inlet and
exhaust camshaft sprockets.
Figure 6A1 – 327
Reinstall
Reinstallation of the camshaft sprockets is the reverse of the removal procedure, noting the following:
1
Align the sprockets and timing chain with the marks made during removal.
2
Tighten the camshaft sprocket bolts to the correct torque specification.
Camshaft sprocket attaching
bolt torque specification . . . . . . ..49.0 – 67.0 Nm
3
Remove the timing chain retention tools.
Engine Mechanical – V6
Page 6A1–201
Page 6A1–201
3.20 Camshaft
Remove
Right-hand Side
1
Remove the right-hand cylinder head camshaft sprockets, refer to
3.18 Camshaft Sprocket
.
N O T E
Tool No. EN-46105–1 was installed as part of the
right-hand cylinder head camshaft sprocket
removal procedure.
2
Remove the Tool No. EN-46105–1 (1) from the right-
hand cylinder head camshafts (2).
N O T E
Tool No. EN-46105 was installed as part of the
right-hand cylinder head camshaft sprocket
removal procedure.
Figure 6A1 – 328
3
Observe the markings (1) on the bearing caps. Each
bearing cap is marked to identify its location. The
markings have the following meanings:
•
The raised feature must always be oriented
toward the centre of the cylinder head.
•
An I indicates the intake camshaft.
•
An E indicates the exhaust camshaft.
•
The number indicates the journal position from
the front of the engine.
Figure 6A1 – 329
Engine Mechanical – V6
Page 6A1–202
Page 6A1–202
4
Remove the camshaft bearing cap bolts (1) and
caps (2).
Figure 6A1 – 330
5
Remove the camshafts (1).
Figure 6A1 – 331
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст