Isuzu KB P190. Service manual — part 174
ANTI-LOCK BRAKE SYSTEM 5B-17
RUW55BMF000101
Legend
(1) Bench Press Fitting
(2) Axle Shaft
(3) Sensor Rotor
Inspection and Repair
Make all necessary adjustments, repairs or part
replacement.
• Check damage or powdered iron sticking to the
sensor rotor.
• Check play in the sensor rotor.
• Check a broken tooth or indentation in the sensor
rotor.
NOTE: If replacement is required, remove the
sensor rotor from the axle shaft assembly with
brake. (Refer to the section Rear Axle).
• Discard the used sensor rotor.
(Snap ring, Oil seal and Bearing)
Installation
1. Install the sensor rotor and assemble it into the
axle shaft assembly with back plate, using setting
tool 9-8522-1271-0. (Refer to the section Rear
Axle)
5B-18 ANTI-LOCK BRAKE SYSTEM
420R300005
Legend
(1) Axle Shaft
(2) Oil Seal
(3)
Bolt
(4) Back Plate
(5) Sensor Rotor
(6) Double Taper Roller Bearing
2. Install the axle shaft assembly with brake in the
rear axle. (Refer to the section Rear Axle).
ANTI-LOCK BRAKE SYSTEM 5B-19
G-Sensor
G-Sensor and Associated Parts
This illustration is based on the RHD model
RTW75BLF000101
Legend
(1)
G-Sensor
(2)
Nut
Removal
1. Remove the front floor console. (Refer to the
section Floor Console)
2. Disconnect the connector.
3. Remove the nuts.
4. Take out the G-sensor.
Installation
1. Set the G-sensor.
2. Install the nut and tighten it to specified torque.
Torque: 8 N·m (0.8 kgf·m / 69 lb·in)
3. Connect the connector.
4. Install the front floor console. (Refer to the section
Floor Console)
5B-20 ANTI-LOCK BRAKE SYSTEM
Special Tools
ILLUSTRATION
PART NO.
PART NAME
ILLUSTRATION
PART NO.
PART NAME
5-8840-2789-0
Installer
9-8522-1271-0
(J-8609-01)
Setting Tool
5-8840-0007-0
(J-8092)
Grip
5-8840-2831-0
Bearing Remover
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст