Isuzu KB P190. Service manual — part 107
4A-12 PROPELLER SHAFT
Removal and Installation
401RS023
Removal
1. Raise the vehicle on a hoist.
NOTE:
Apply alignment marks on the flange at the rear
propeller shaft both front and rear side.
2. Remove center bearing fixing bolt.
3. Remove rear axle side bolt, nut and washer.
4. Remove rear propeller shaft.
NOTE:
Plug the hole of the transmission rear end to prevent oil
leakage.
401L100007
Installation
NOTE:
Cover the slip yoke with cloth to avoid damage to the oil seal
contact surface, when removing propeller shaft from
transmission. Do not damage the oil seal contact surface of
slip yoke with other parts at removal and installation.
Completely remove the dust or foreign matter from the
connecting surface of flange coupling on each end of the
propeller shaft.
1. Align the mark which is applied at removal and insert the
propeller shaft in the transmission.
2. Install rear propeller shaft and tighten the bolts to the
specified torque.
Torque: 59 N
⋅⋅⋅⋅m (6.0 kgf⋅⋅⋅⋅m/43 lb⋅⋅⋅⋅ft)
3. Install center bearing and tighten the bolts to the specified
torque.
Torque: 69 N
⋅⋅⋅⋅m (7.0 kgf⋅⋅⋅⋅m/51 lb⋅⋅⋅⋅ft)
PROPELLER SHAFT 4A-13
Universal Joint Disassembly
401R300002
Legend
1.
Snap
Ring
2. Needle Roller Bearing
3.
Spider
4.
Yoke
4A-14 PROPELLER SHAFT
401R300003
1. Remove the snap rings.
• Apply alignment marks on the yokes of the universal
joint.
401R300004
2. Remove the needle roller bearings.
• Tap out the bearing by gently striking the shoulder of the
yoke, using a mallet or a copper hammer.
3. Remove the spider.
• Make sure of proper position for reinstallation by
applying setting marks.
4. Remove the yoke.
PROPELLER SHAFT 4A-15
Inspection and Repair
Make all necessary adjustment, repairs, and part replacements if wear, damage, or other problems are discovered
during inspection.
Visual Check
Inspect following parts for wear, damage, or other abnormal
conditions.
Spider
Needle roller bearing
Yoke
Flange
Center bearing
Cushioning rubber
Bracket
401RS007
Outside Diameter of Spider Pins
mm(in)
Standard Limit
17 (0.67)
16.99 (0.669)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст