Isuzu KB P190. Service manual — part 1167
7B1-62 MANUAL TRANSMISSION
Removal
1. Disconnect the battery ground cable.
2. Remove the gear control lever knob.
3. Remove the rear floor console. (Bucket seat)
Refer to the section “Floor Console”.
4. Remove the front floor console.
Refer to the section “Floor Console”.
745R300006
Legend
(1) Knob
(2) Rear Floor Console
(3) Front Floor Console
5. Remove the grommet assembly.
RTW47BMH000101
Legend
(1)
Grommet Assembly
(2)
Floor Panel
(3)
Front
MANUAL TRANSMISSION 7B1-63
6. Remove the gear control lever.
7. Raise and support the vehicle with suitable stands.
8. Remove the rear propeller shaft.
NOTE: Apply alignment marks on the flange at the
differential side.
9. Remove the front propeller shaft.
NOTE: Apply alignment marks on the flange at both
front and rear sides.
401RS023
10. Loosen the front exhaust pipe fixing nuts at the
engine side but do not remove them. (Diesel engine
only)
RTW67BSH000101
11. Disconnect the harness connectors and clips on the
transmission and transfer.
• Neutral Switch: Transmission
• Back up Switch
• Actuator
• 2WD-4WD
Switch
• Neutral Switch: Transfer
• Car Speed Sensor
810R300069
Legend
(1)
Neutral Switch Connector: Transmission
(2)
Back up Switch Connector
(3)
Speed Sensor Connector
(4)
Actuator Connector
(5)
2WD - 4WD Switch Connector
(6)
Neutral Switch Connector: Transfer
7B1-64 MANUAL TRANSMISSION
12. Remove the fuel pipe brackets with pipes from the
transmission.
Diesel engine
220R300012
Legend
(1) Bolt
(2) Nut
(3) Fuel Pipe Assembly
C24SE
Scan-2
13. Remove the slave cylinder and put it aside.
220LV019
14. Support the transmission with a transmission jack.
220RS0001
15. Remove the engine rear mount nuts from the
transmission crossmember.
MANUAL TRANSMISSION 7B1-65
16.
Remove the engine rear mount bolts fixing
transmission.
220R300009
17.
Remove the middle part of the transmission
crossmember by removing the four fixing bolts and
nuts.
501R30007
18. Take out the rear support rubber.
19. Remove the starter. (Diesel engine only)
060L100070
20. Remove the transmission retaining nuts and bolts.
Remove the transmission assembly
from the
vehicle.
21. Remove the transmission–transfer fixing bolts and
nut, and disassemble the transfer from the
transmission.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст