Isuzu KB P190. Service manual — part 1183
Manual Transmission (MUX) 7B1-13
16. Install the front propeller shaft. (4x4 model)
• Tighten the front propeller shaft bolts to the
specified torque.
Torque: 59 N
⋅m (6.0 kgf⋅m/43 lb⋅ft)
17. Install the rear propeller shaft.
• Tighten the rear propeller shaft bolts to the
specified torque.
Torque
Rear flange: 59 N
⋅m (6.0 kgf⋅m/43 lb⋅ft)
Center bearing: 69 N
⋅m (7.0 kgf⋅m/51 lb⋅ft)
18. Connect harness clip on the transmission left side
bracket.
Install the harness bracket bolt.
• Tighten the harness bracket bolt to the
specified torque.
Torque: 23 N
⋅m (2.3 kgf⋅m/17 lb⋅ft)
19. Connect the harness connectors and clips on the
transmission.
Legend
1. Neutral switch connector
2. Clutch damper valve connector
Legend
3. Clip
4. Reverse switch connector
5. 1st switch connector
RTW77BSH000301
RTW77BSH006601
1
2
RTW77BSH006701
3
3
5
4
7B1-14 Manual Transmission (MUX)
Legend
6. Car speed sensor conector
7. Clip
8. 2-4 switch connector (4x4 model)
9. Neutral switch connector (4x4 model)
10. Transfer actuator connector (4x4 model)
20. Install the clutch housing cover and clutch bearing
dust cover.
• Tighten the clutch housing cover bolts and
clutch bearing dust cover bolts to the specified
torque.
Torque: 8 N
⋅m (0.8 kgf⋅m/69 lb⋅in)
21. Install the gear control lever (1).
• Tighten the gear control lever bolts to the
specified torque.
Torque: 19 N
⋅m (1.9 kgf⋅m/14 lb⋅ft)
22. Install the grommet assembly.
• Tighten the grommet bolts to the specified
torque.
Torque
Screw: 1.4 N
⋅m (0.14 kgf⋅m/12 lb⋅in)
Nut: 7 N
⋅m (0.7 kgf⋅m/61 lb⋅in)
Legend
1. Grommet Assembly
2. Floor Panel
3. Front
23. Install the front floor console.
Refer to the section "Floor Console".
24. Install the rear floor console. (Bucket seat)
Refer to the section "Floor Console".
RTW77BSH006801
10
9
6
7
8 7
RTW77BSH007101
1
RTW77BMH000101
1
2
3
Manual Transmission (MUX) 7B1-15
25. Install the gear control knob.
Legend
1. Knob
2. Rear Floor Console
3. Front Floor Console
26. Connect battery ground cable.
RTW77BSH000101
1
3
2
7B1-16 Manual Transmission (MUX)
Transmission
Component
Legend
1. Front case assembly with clutch housing
2. Front cover
3. Reverse switch
4. 1st switch
5. Reverse detent assembly
6. Neutral switch
7. Intermediate plate assembly
8. 5th detent assembly
9. Filler plug
10. Drain plug
11. Rear case assembly
12. End cover assembly (4x4 model)
13. Output shaft snap ring
14. Output rear bearing inner race
15. Speedometer driven gear
16. End cover assembly (4x2 model)
17. End cover gasket
18. Gear set clip
19. Speedometer drive gear
20. Straight plug
21. Dowel
22. Control rod detent assembly
23. Quadrant box
RTW77BLF001901
16
17
18
19
13
14
1
23
22
20
12
13
14
2
3
4
5
6
21
21
11
10
9
8
7
15
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст