Isuzu KB P190. Service manual — part 729
Engine Mechanical – V6
Page 6A1–139
Page 6A1–139
34
Verify the left-hand secondary timing chain timing
mark alignments (1 to 6).
Figure 6A1 – 170
Left-hand Secondary Timing Chain Components – MY06 Update
1
Install the crankshaft sprocket (1) onto the
crankshaft (2) by aligning the keyway to the key on
the crankshaft.
2
Slide the crankshaft sprocket on the crankshaft until
the crankshaft sprocket contacts the step in the
crankshaft.
Figure 6A1 – 171
N O T E
Ensure that the crankshaft sprocket is installed
with the timing mark (1) visible.
Figure 6A1 – 172
Engine Mechanical – V6
Page 6A1–140
Page 6A1–140
CAUTION
In order to install Tool No. EN 46105 onto the
camshafts, rotate the camshafts in an anti-
clockwise direction. There should be no
need to rotate the camshaft more than 45
degrees.
Figure 6A1 – 173
3
Install Tool No. EN 46105-1 (1) onto the rear of the
left-hand cylinder head camshafts (2).
CAUTION
All camshafts must be locked in place before
installation of any timing chains.
4
Ensure that Tool No. EN 46105 is fully seated onto
the camshafts.
Figure 6A1 – 174
5
Using Tool No. EN46111 (1), rotate the crankshaft in
a clockwise direction until the crankshaft sprocket
timing mark (2) is aligned with the indexing mark (3)
on the oil pump housing.
Figure 6A1 – 175
Engine Mechanical – V6
Page 6A1–141
Page 6A1–141
6
Install the left-hand secondary timing chain (1)
aligning the chain in the following manner:
Figure 6A1 – 176
7
Wrap the secondary timing chain around both left-
hand camshaft drive sprockets.
8
Ensure there are two bright links located on top of
each of the camshaft sprockets.
Figure 6A1 – 177
Engine Mechanical – V6
Page 6A1–142
Page 6A1–142
CAUTION
When aligning the left-hand secondary timing
chain to the camshaft sprockets, ensure the
circular timing marks on the sprocket are
used, NOT the triangular mark.
9
Align the bright plated timing chain link (1) with the
left-hand exhaust camshaft position sprocket
alignment circle mark (2).
Figure 6A1 – 178
10
Align the bright plated timing chain link (1) with the
intake camshaft position sprocket alignment circle
mark (2).
Figure 6A1 – 179
CAUTION
The left-hand camshaft intermediate
sprocket (1) is marked with the letters LB
and ‘FRONT’, and the right-hand sprocket (2)
is marked with the letters RB and 'FRONT'
Ensure the correct sprocket is used and the
'FRONT' text is facing forwards when
installed.
11
Ensure the left-hand camshaft intermediate sprocket
is selected and orientated correctly.
Figure 6A1 – 180
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст