Isuzu KB P190. Service manual — part 167
BRAKE CONTROL SYSTEM 5A-75
Step Action Value(s) Yes
No
3
1. Ignition “ON”, engine “OFF”.
2. Select “Display DTCs” with the Tech 2.
Note: Perform the various tests (actuator test, test
run, brake test, etc.) then observe the DTC with a
Tech 2.
Are any DTCs stored?
-
Go to Step 4
Verify repair
4 Replace
EHCU.
Note: Check the EHCU type for specification, when
the EHCU is replaced.
(Specification ; 2WD model or 4WD model)
Is the action complete?
-
Verify repair
-
5A-76 BRAKE CONTROL SYSTEM
DTC C0271 (Flash Code 71) ECU Malfunction
RTW75ALF000301
Step Action Value(s) Yes
No
1
Were the steps of the “Basic Diagnostic Flow Chart”
performed?
-
Go to Step 2
Go to Basic
Diagnostic
Flow Chart
2
1.
Ignition
“OFF”.
2. Check the EHCU circuit for an open, short to
ground, or short to voltage. Also, check the EHCU
ignition feed circuit for an open or short to ground
and the EHCU ground circuit for an open or short to
voltage.
3. If a problem is found, repair as necessary.
Was a problem found?
-
Verify repair
Go to Step 3
BRAKE CONTROL SYSTEM 5A-77
3
1. Ignition “ON”, engine “OFF”.
2. Select “Display DTCs” with the Tech 2.
Note: Perform the various tests (actuator test, test
run, brake test, etc.) then observe the DTC with a
Tech 2.
Are any DTCs stored?
-
Go to Step 4
Verify repair
4 Replace
EHCU.
Note: Check the EHCU type for specification, when
the EHCU is replaced.
(Specification ; 2WD model or 4WD model)
Is the action complete?
-
Verify repair
-
5A-78 BRAKE CONTROL SYSTEM
DTC C0276 (Flash Code 76) G Sensor Malfunction
RTW75AMF001501
Step Action Value(s) Yes
No
1
Were the steps of the “Basic Diagnostic Flow Chart”
performed?
-
Go to Step 2
Go to Basic
Diagnostic
Flow Chart
2
1. Check for a poor connection at the G sensor
harness connector.
2. If a problem is found, repair as necessary.
Was a problem found?
-
Verify repair
Go to Step 3
3
1. Ignition “OFF”, disconnect the G sensor and EHCU.
2. Ignition “ON”, engine “OFF”.
3. Check the supply voltage to G sensor.
Was the value normal?
Battery
Voltage
Go to Step 5
Go to Step 4
4
Repair or replace the power supply circuit.
Is the action complete?
-
Verify repair
-
5
1. Check the circuit between EHCU and G sensor.
(Check circuit for an open, short to ground, or short
to voltage.)
2. If a problem is found, repair as necessary.
Was a problem found?
-
Verify repair
Go to Step 6
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст