Isuzu KB P190. Service manual — part 1270
8A-142 ELECTRICAL-BODY AND CHASSIS
REMOVAL AND INSTALLATION
FUEL GAUGE UNIT AND SENDER
ASSEMBLY
Removal
1. Remove the fuel gauge unit and sender assembly.
Refer to the “ENGINE FUEL” Section 6C of this Manual.
Installation
To install the fuel gauge unit and sender assembly, follow the
removal procedure in reverse order.
Pay close attention to the important points mentioned in the
following paragraphs.
Rubber Seal
Be absolutely sure that the fuel sender rubber seals are
correctly seated.
Connector
Be absolutely sure that the fuel gauge unit connector is
securely connected.
This will prevent a poor contact and an open circuit.
ELECTRICAL-BODY AND CHASSIS 8A-143
EXHAUST GAS RECIRCULATION (EGR) & GLOW; 4JA1T (L) ONLY
PARTS LOCATION (RHD)
RTW78AXF036501 & RTW78AMF001101
8A-144 ELECTRICAL-BODY AND CHASSIS
PARTS LOCATION (RHD)
RTW78AXF042701
ELECTRICAL-BODY AND CHASSIS 8A-145
PARTS LOCATION (LHD)
RTW78AXF036601 & RTW78AMF001101
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст