Isuzu KB P190. Service manual — part 1452
10-50 CAB
RTW710SH000501
Important Operations - Removal
3. Front Pillar Trim Cover
• Turn up the finisher and pry the trim cover clips free
from the body panel.
Remove the trim cover by pulling upward on the lower
part of it.
4. Rear End Trim Cover
• Pry the trim cover clips free from the body panel, and
slide the trim cover upward to remove it.
5. Body Side Rear Lower Trim Cover
• Pry the trim cover clips free from the body panel.
7. Tongue Side Seat Belt
1) Pull out the adjuster knob.
RTW5A0SH000501
2) Remove the through ring anchor cover and remove the
seat belt upper anchor bolt.
• Insert the blade of an ordinary screwdriver into the gap
between the D-ring back surface and the cover.
Carefully pry the D-ring latches open. Remove the cover.
CAB 10-51
8. Body Side Rear Upper Trim Cover
• Pry the trim cover clips free from the body panel.
Important Operations - Installation
7. Tongue Side Seat Belt
• Tighten the seat belt upper anchor bolt to the specified
torque.
Torque N
⋅m (kgf⋅m/lb⋅ft)
40 (4.1/30)
4. Rear End Trim Cover
• Insert the hooks on the back upper portion of the trim
cover to the body panel.
10-52 CAB
REMOVAL AND INSTALLATION
RTW4A0MF000401
Crew Cab Model
Removal Steps
▲ 1. Front sill plate/Rear sill plate
2. Dash side trim cover
▲ 3. Front pillar trim cover
▲ 4. Center pillar lower trim cover
5. Front door finisher
6.
Cover
▲ 7. Rear end trim cover
▲ 8. Body side rear lower trim cover
9. Rear door finisher
▲10. Front tongue side seat belt
▲11. Center pillar upper trim cover
12. Rear tongue side seat belt
▲13. Body side rear upper trim cover
Installation Steps
13. Body side rear upper trim cover
▲12. Rear tongue side seat belt
11. Center pillar upper trim cover
▲10. Front tongue side seat belt
9 Rear door finisher
8. Body side rear lower trim cover
▲ 7. Rear end trim cover
6.
Cover
5. Front door finisher
4. Center pillar lower trim cover
3. Front pillar trim cover
2. Dash side trim cover
1. Front sill plate/Rear sill plate
CAB 10-53
Important Operations - Removal
1. Front Sill Plate/Rear Sill Plate
• Pull out the 4 clip positions (Front).
• Pull out the 2 clip positions (Rear).
3. Front Pillar Trim Cover
• Turn up the finisher and pry the trim cover clips free
from the body panel.
Then remove the trim cover by pulling upward on the
lower part of it.
4. Center Pillar Lower Trim Cover
• Pry the trim cover clips free from the body panel.
7. Rear End Trim Cover
• Pry the trim cover clips free from the body panel, and
slide the trim cover upward to remove it.
8. Body Side Rear Lower Trim Cover
• Pry the trim cover clips free from the body panel.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст