Isuzu Trooper (1998-2002 year). Service manual — part 2
VEHICLE IDENTIFICATION NUMBER (VIN)
This is the legal identification of the vehicle.
It appears on the manufacturer’s Plate attached to the left
of the engine compartment front end. VIN number is also
stamped on the rear right side of the frame.
VIN
VIN
ISUZU MOTORS LTD.
JAC
UBS
25
G
Y
7
200001
Sequential Number
Plant Code
Model Year (Y: 2000)
Wheel Base (D: Short, G: Long)
Engine Type (25: 6VD1, 26: 6VE1, 69: 4JG2, 73: 4JX1)
Vehicle Model
World Manufacturer Identifier
ENGINE SERIAL NUMBER
The engine serial number is stamped on the left rear lower
area of the cylinder block above the starter.
4JG2
0A–6 GENERAL INFORMATION
IDENTIFICATION
905RY00014
4JX1
905RW014
GENERAL INFORMATION 0A–7
TRANSMISSION SERIAL NUMBER
Manual: Stamped on the left side of the transmission
intermediate plate.
Automatic: Stamped on the identification plate, located on
the left side of the transmission above the
mode switch.
96
0000 000
018
PART No.
SERIAL No.
SAL
HYDRAMATIC
STRASBOURG
MADE IN FRANCE
G 20
272
FP
SERVICE PARTS IDENTIFICATION PLATE
The Vehicle Information Plate (Service Parts ID plate) is
provided on all vehicle models.
It is located on the center dash wall inside the engine
compartment. The plate lists the VIN (Vehicle Identification
Number), paint information and all production options and
special equipment on the vehicle when it was shipped
from the factory.
Service parts ID plate
ISUZU MOTORS L T D. JAPAN
V.I.N.
M.D.
ENGINE
GRADE
TRANS.
TIRE
BODY TYPE
B. COLOR/TRIM
OPTION
6VE1
and
6VD1
905RY00013
905RW015
905RW018
905RW007
0A–8 GENERAL INFORMATION
LIFTING INSTRUCTIONS
CAUTION:
•
If a lifting device other than the original jack
is used, it is most important that the device
be applied only to the correct lifting points.
Raising the vehicle from any other point
may result in serious damage.
•
When jacking or lifting a vehicle at the
frame side rail or other prescribed lift
points, be certain that lift pads do not
contact the catalytic converter, brake
pipes or cables, or fuel lines. Such contact
may result in damage or unsatisfactory
vehicle performance.
LIFTING POINTS AND SUPPORTABLE POINT LOCATIONS
Long wheel Base Model
Short Wheel Base Model
Lifting point
Supportable point
GENERAL INFORMATION 0A–9
LIFTING POINT; FRONT
When using floor jack, lift on the center of the skid plate.
SUPPORTABLE POINT; FRONT
Position the chassis stands at the bottom of the frame
sidemember, backward of front wheel.
LIFTING POINT; REAR
Position the floor jack at the center of the rear axle case
when lifting the vehicle.
SUPPORTABLE POINT; REAR
Position the chassis stands at the bottom of the frame
sidemember, just behind of the trailing link bracket.
SUPPORTABLE POINT; REAR
Position the chassis stands at the bottom of the rear axle
case.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст