Isuzu Trooper (1998-2002 year). Service manual — part 724
AUTOMATIC TRANSMISSION (AW30-40LE)
7A–93
DISASSEMBLY OF MAJOR COMPONENTS (2)
242RY00005
Disassembly steps
▲
1. Converter housing
▲
2. Oil pan
▲
3. Oil strainer assembly
▲
4. Solenoid wiring
▲
5. Valve body
▲
6. Check valve, spring
▲
7. Spring
▲
8. Accumulator piston (B-2)
▲
9. Accumulator piston (C-2)
▲
10. Accumulator piston (B-0)
▲
11. Accumulator piston (C-0)
12. Second brake drum gasket
7A–94
AUTOMATIC TRANSMISSION (AW30-40LE)
240RY00006
240RY00007
240RY00008
244RY00003
Important operations
1. Converter housing
Remove the six bolts.
Remove the transmission housing.
2. Oil pan
NOTE:
Do not turn over the transmission as this will contaminate
the valve body with foreign materials in the bottom of the
pan.
Remove the nineteen bolts.
Remove pan by lifting the transmission case.
Seal cutter: 5-8840-2153-0 (J-37228)
Examine particles in pan
Remove the magnet and use it to collect any steel chips.
Look carefully at the chips and particles in the pan and on
the magnet to anticipate what type of wear you will find in
the transmission:
Steel (magnetic). .bearing, gear and clutch plate wear
Brass (non-magnetic)...bushing wear
3. Oil strainer assembly
Remove four bolts holding the oil strainer.
NOTE:
When reassembling components, install a new oil strainer
assembly.
AUTOMATIC TRANSMISSION (AW30-40LE)
7A–95
249RY00011
249RY00012
244RY00017
240RY00028
4. Solenoid wiring
Disconnect the connectors from the solenoid S1(1), S2(2),
lock-up solenoid (3) and pressure control solenoid (4).
Turn over transmission, remove the solenoid wiring stopper
plate from the case.
Pull the wiring out of the transmission case.
5. Valve body
Remove the twenty bolts from valve body.
6. Check valve, spring
7. Spring
Remove the check valve and spring.
Remove two springs from C-0 accumulator piston.
7A–96
AUTOMATIC TRANSMISSION (AW30-40LE)
240RY00010
240RY00011
240RY00012
8. Accumulator piston (B-2)
9. Accumulator piston (C-2)
Remove accumulator pistons and springs from
transmission case.
10. Accumulator piston (B-0)
Applying compressed air to the oil hole, remove the B-0
accumulator piston and spring.
11. Accumulator piston (C-0)
Remove the C-0 accumulator piston.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст