Opel Insignia (2019 year). Instruction — part 17
262
Vehicle care
Rear window
Grand Sport
Lift the wiper arm until it stays in the
raised position, press button to
disengage the wiper blade and
remove.
Attach the wiper blade slightly angled
to the wiper arm and push until it
engages.
Lower wiper arm carefully.
Sports Tourer, Country Tourer
Lift wiper arm. Disengage wiper blade
as shown in illustration and remove.
Attach the wiper blade slightly angled
to the wiper arm and push until it
engages.
Lower wiper arm carefully.
Bulb replacement
Switch off the ignition and switch off
the relevant switch or close the doors.
Only hold a new bulb at the base. Do
not touch the bulb glass with bare
hands.
Use only the same bulb type for
replacement.
Replace headlight bulbs from within
the engine compartment.
Bulb check
After a bulb replacement switch on
the ignition, operate and check the
lights.
Halogen headlights
Halogen headlights with separate
bulbs for low beam and high beam.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
263
Low beam (1) outer bulb.
High beam (2) inner bulb.
Low beam (1)
1. Rotate the cap anticlockwise and
remove it.
2. Disengage bulb holder by
pressing the retainer to the front.
Withdraw the bulb holder from the
reflector housing.
3. Detach the bulb from the bulb
holder and replace the bulb.
4. Insert the bulb holder.
5. Fit the cap and rotate clockwise.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
264
Vehicle care
High beam (2)
1. Rotate the cap anticlockwise and
remove it.
2. Disengage bulb holder by
pressing the retainer to the front.
Withdraw the bulb holder from the
reflector housing.
3. Detach the bulb from the bulb
holder and replace the bulb.
4. Insert the bulb holder.
5. Fit the cap and rotate clockwise.
Front turn signal light
In case of defective LEDs, have them
replaced by a workshop.
Side light
In case of defective LEDs, have them
replaced by a workshop.
Daytime running light
In case of defective LEDs, have them
replaced by a workshop.
LED headlights
Headlights for low and high beam,
sidelights, daytime running lights and
turn signal lights are designed as
LEDs and cannot be changed.
Have lights repaired by a workshop in
case of failure.
Front fog lights
1. Grand Sport, Sports Tourer
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
265
Wrap a cloth around the tip of a flat
screwdriver to prevent paint
damage. Insert the screwdriver in
the recess at the edge of the
cover. Release the cover by
levering it out carefully.
Country Tourer
Undo the screw with a torx
screwdriver.
2. Grand Sport, Sports Tourer
Undo screw with the torx
screwdriver and remove the
faceplate.
Country Tourer
Wrap a cloth around the tip of the
flat screwdriver to prevent paint
damage. Lever out the faceplate
by inserting the screwdriver in the
recess and remove it.
3. Undo three screws with the torx
screwdriver and remove the light
assembly to the front.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
266
Vehicle care
4. Turn the bulb socket
anticlockwise and remove it from
the light assembly.
5. Disengage the plug connector by
pressing the retaining lug.
6. Remove and replace the bulb unit
and attach the plug connector.
Note that the bulb and the socket
are one unit and have to be
changed together.
7. Insert the bulb socket into the light
assembly by turning clockwise
and engage.
8. Mount the light assembly by
tightening the three screws.
9. Attach the faceplate and tighten
the screw.
10. Grand Sport, Sports Tourer
Attach and engage the cover.
Tail lights
Tail lights and brake lights are
designed as LEDs. In case of failure,
have LEDs replaced by a workshop.
Turn signal lights, rear fog lights and
reverse lights are designed for bulbs
and can be changed as follows.
Grand Sport
Light assembly in the body
1. Remove the cover on the
respective side.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
267
2. Unscrew the two plastic securing
nuts from the inside by hand.
3. Carefully withdraw tail light
assembly from recess and
remove. Take care that the cable
duct remains in position.
4. Turn the turn signal light bulb
socket anticlockwise and remove
it from the light assembly.
5. Remove and replace the turn
signal light bulb.
6. Attach the bulb socket to the light
assembly.
7. Attach the light assembly to the
vehicle body and tighten the
securing nuts from the inside of
the load compartment. Attach
cover.
Light assembly in the tailgate
1. Release the cover in the tailgate
and remove it.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
268
Vehicle care
2. Unscrew the plastic securing nut
by hand.
3. Carefully withdraw the light
assembly from the recesses and
remove. Take care that the cable
duct remains in position.
4. Turn the bulb socket
anticlockwise and remove it from
the light assembly.
Rear fog light (1)
Reverse light (2)
5. Detach the bulb from the bulb
socket and replace the bulb.
Rear fog light
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
269
Reverse light
6. Insert the bulb socket into the tail
light assembly. Fit light assembly
on the tailgate and tighten the
screw from the inside. Attach
cover.
Sports Tourer, Country Tourer
Light assembly in the body
1. Open the covers with screwdriver.
Unscrew and remove both
screws.
2. Carefully withdraw tail light
assembly from recess and
remove. Take care that the cable
duct remains in position.
3. Turn the turn signal light bulb
socket anticlockwise and remove
it from the light assembly.
4. Detach the bulb from the bulb
socket and replace the turn signal
light bulb.
5. Attach the bulb socket to the light
assembly.
6. Attach the light assembly to the
vehicle body and tighten the
screws. Close covers.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
270
Vehicle care
Light assembly in the tailgate
1. Release the cover in the tailgate
and remove it.
2. Unscrew the plastic securing nut
by hand.
3. Carefully withdraw the light
assembly from the recesses and
remove. Take care that the cable
duct remains in position.
4. Turn the bulb socket
anticlockwise and remove it from
the light assembly.
Rear fog light (1)
Reverse light (2)
5. Detach the bulb from the bulb
socket and replace the bulb.
Rear fog light
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
271
Reverse light
6. Insert the bulb socket into the tail
light assembly. Fit light assembly
on the tailgate and tighten the
screw from the inside. Attach
cover.
Side turn lights
To replace bulb, remove lamp
housing:
1. Slide lamp to its left side and
remove with its right end.
2. Turn bulb holder anticlockwise
and remove from housing.
3. Pull bulb from bulb holder and
replace it.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
272
Vehicle care
4. Insert bulb holder and turn
clockwise.
5. Insert left end of the lamp, slide to
the left and insert right end.
Number plate light
The number plate light is designed as
LEDs and can not be changed. In
case of defective LEDs, have them
replaced by a workshop.
Interior lights
Courtesy light, reading lights
Have bulbs replaced by a workshop.
Load compartment light
Have bulbs replaced by a workshop.
Instrument panel
illumination
Have bulbs replaced by a workshop.
Electrical system
Fuses
Data on the replacement fuse must
match the data on the defective fuse.
There are three fuse boxes in the
vehicle:
● engine compartment
● instrument panel
Before replacing a fuse, turn off the
respective switch and the ignition.
A blown fuse can be recognised by its
melted wire.
Caution
Do not replace the fuse until the
cause of the fault has been
remedied.
Some functions are protected by
several fuses.
Fuses may also be inserted without
existence of a function.
Fuse extractor
A fuse extractor may be located in the
fuse box in the engine compartment.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
273
Place the fuse extractor on the
various types of fuse from the top or
side, and withdraw fuse.
Engine compartment fuse
box
The fuse box is in the front left of the
engine compartment.
Disengage the cover and remove it.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
274
Vehicle care
No. Circuit
1
–
2
–
3
ABS
4
–
5
–
6
Tailgate
7
Fog light
8
Memory module
9
Heated windscreen
10 Seat lumbar
11 DC/DC battery
12 Heated rear window
13 Heated mirror
14 –
15 –
16 Front wiper
17 Power seat, passenger
No. Circuit
18 Sunblind
19 Power seat, driver
20 –
21 Sunroof
22 Rear wiper/Airbag
23 Adaptive forward lighting
24 –
25 –
26 Transmission control module
27 Ignition/Instrument panel
28 –
29 Rear view camera/Air vent
30 Malfunction indicator light/
Trailer
31 –
32 Camera
33 Seat heat front
34 Seat heat rear
No. Circuit
35 Damping/All-wheel drive
36 Fuel system
37 –
38 –
39 –
40 Steering wheel lock
41 –
42 –
43 Heated steering wheel
44 Headlight range adjustment
45 –
46 Engine control module
47 –
48 DC/DC converter/Air vent/E-
Boost
49 Rear door control module
50 –
51 –
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
275
No. Circuit
52 –
53 –
54 –
55 –
56 Starter
57 –
58 –
59 Left headlight (LED)
60 Cooling fan
61 –
62 –
63 –
64 –
65 Climate control
66 –
67 –
68 –
No. Circuit
69 Right high beam (Halogen)/
Right headlight (LED)
70 Left high beam (Halogen)
71 –
72 Starter
73 –
74 Transmission control module
75 Engine control module
76 Exhaust reduction system
77 –
78 Horn
79 Washer system
80 –
81 Engine control module
82 –
83 Ignition coil
84 Ignition coil
85 Powertrain
No. Circuit
86 –
87 Diesel fuel heating
88 Air shutter
89 –
90 –
91 –
92 After boil pump
93 Electronic key system
94 –
95 Coolant pump
96 Diesel fuel heating
97 –
98 –
99 Coolant pump
After having changed defective fuses,
close the fuse box cover and press
until it engages.
If the fuse box cover is not closed
correctly, malfunction may occur.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
276
Vehicle care
Instrument panel fuse box
In left-hand drive vehicles, the fuse
box is behind a cover in the
instrument panel.
Disengage cover at the side and
remove.
In right-hand drive vehicles, the fuse
box is located behind a cover in the
glovebox. Open the glovebox and
remove the cover.
No. Circuit
1
Left power window
2
Right power window
3
Body control module
4
Climate control fan
5
Body control module
6
Trailer provisions
7
Rear seat power folding
8
Body control module
9
Engine control module
10 Head-up display
11 NO
x
reduction/Pipe heater
12 NO
x
reduction/Soot sensor
13 AdBlue module
14 Heated steering wheel
15 Transmission control module
16 Amplifier
17 Alarm
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Vehicle care
277
No. Circuit
18 Body control module
19 AdBlue module
20 Body control module
21 Body control module
22 Body control module
23 Electric steering wheel lock
24 Airbag
25 Diagnostic connector
26 Power outlet load compartment
27 EBCM valve
28 Police provision
29 –
30 –
31 Steering wheel controls
32 Ignition switch
33 Climate control
34 Central gateway module
No. Circuit
35 AUX/USB connector
36 Wireless charger
37 Rear wiper
38 OnStar module
39 Display
40 Parking assist
41 Overhead console
42 Infotainment System
Vehicle tools
Tools
Vehicles with spare wheel
The jack with wheel wrench, the tools,
an extension bolt for securing a
damaged wheel and the towing eye
are placed in the tool box below the
spare wheel in the load compartment.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст