Opel Frontera UBS. Service manual — part 24
1A – 12 HEATING AND VENTILATION
Removal Steps
1. Heater unit
2. Case (Temperature control)
3. Rod
4. Sub-lever
5. Door lever
6. Clip
Installation Steps
To install, follow the removal steps in the
reverse order.
HEATER TEMPERATURE CONTROL LINK UNIT
2
5
6
6
4
5
1
3
This illustration is based on LHD
HEATING AND VENTILATION 1A – 13
REMOVAL
Preparation:
•
Disconnect the battery ground cable
•
Drain engine coolant
1. Heater Unit
Refer to “HEATER UNIT” removal procedure in this
section.
2. Case (Temperature Control)
Remove the case (Temperature control) from the
heater unit.
3. Rod
4. Sub-Lever
5. Door Lever
Pull out the door lever while raising up the catch of
the door lever.
6. Clip
INSTALLATION
To install, follow the removal steps in the reverse order,
noting the following points:
1. Apply grease to sub-lever and to the abrasive surface
of the heater unit.
2. After installing the link unit, check to see if the link
unit operates correctly.
1A – 14 HEATING AND VENTILATION
Removal Steps
1. Instrument panel assembly
2. Resistor connector
3. Duct
3a. Evaporator assembly (A/C only)
4. Kick panel
5. Blower motor connector
6. Blower assembly
Installation Steps
To install, follow the removal steps in the
reverse order.
BLOWER ASSEMBLY
2
3a(With A/C)
3
Heater unit
Electro thermo connector
(With A/C)
1
4
6
5
This illustration is based on LHD
HEATING AND VENTILATION 1A – 15
REMOVAL
Preparation:
•
Disconnect the battery ground cable
•
Discharge and recover refrigerant (W/A/C)
(Refer to Section 1B “REFRIGERANT RECOVERY”)
1. Instrument Panel Assembly
Refer to Section 10 “BODY” for INSTRUMENT PANEL
ASSEMBLY removal procedure.
2. Resistor Connector
3. Duct
3a. Evaporator Assembly (A/C only)
Refer to Section 1B “AIR CONDITIONING” for
EVAPORATOR ASSEMBLY removal procedure.
4. Kick panel
5. Blower Motor Connector
6. Blower Assembly
INSTALLATION
To install, follow the removal steps in the reverse order,
noting the following point:
1. Adjust Control Lever Assembly Cables
Refer to “CONTROL LEVER ASSEMBLY” installation
procedure in this section.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст