Opel Frontera UBS. Service manual — part 1737
8F–19
BODY STRUCTURE
4. Remove radiator grille.
D
Raise the clips (1) on the radiator grille and remove
two screws.
603RW012
5. Remove front end lower panel.
D
Remove two fixing bolts and remove the panel from
the fender.
Installation
To install, follow the removal steps in reverse order, noting
the following point.
1. Install the radiator grille clips remaining on the body
side in the radiator grille, and then install the radiator
grille on the body.
8F–20
BODY STRUCTURE
Front Fender Panel
Parts Location
605RW008
Legend
(1) Cowl Cover
(2) Front Mud Flap
(3) Antenna Bezel
(4) Side Turn Signal Light
(5) Front Fender Panel
(6) Front Combination Light Assembly
(7) Inner Liner
Removal
1. Open the hood.
2. Support the hood.
3. Disconnect the battery ground cable.
4. Remove cowl cover.
D
Refer to Cowl Cover in this section.
5. Remove front combination lamp assembly.
D
Disconnect fixing screw and connector.
6. Remove front mud flap.
D
Disconnect three fixing screws and four clips.
7. Remove inner liner.
8. Remove antenna bezel.
D
Refer to Antenna in Entertainment section.
9. Remove side turn signal light.
D
Refer to Side Turn Signal Light Bulb in Lighting
System section.
8F–21
BODY STRUCTURE
10. Remove front fender panel.
D
Disconnect ten fixing bolts and two nuts.
605RW001
Installation
To install, follow the removal steps in the reverse order
noting the following points:
1. Tighten the front fender panel fixing bolts to the
specified torque.
(1) Torque : 9 N
•
m (0.9kg·m/78 lb in)
(2) Torque : 7 N
•
m (0.7kg·m/61 lb in)
8F–22
BODY STRUCTURE
Body Mounting
Parts Location
E02RW006
Removal (No.1 – No. 2)
1. Remove the front bumper.
2. Jack up the vehicle by the frame.
3. Support the front side sill and rear axle with stands.
Further, support the front jack up point with a jack.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст