Opel Frontera UBS. Service manual — part 2903
EXTERIOR/INTERIOR TRIM
8J–23
Front Pillar Trim Cover
Front Pillar Trim Cover and
Associated Parts
743RS003
Legend
(1) Roof Side Trim Panel
(2) Assist Grip
(3) Front Pillar Trim Panel
Removal
1. Remove the front pillar assist grip(1).
D
Open the both sides of the assist grip cover (2) and
remove the fixing screws and the front pillar assist
grip.
743RW003
2. Remove the front pillar trim cover (3).
D
Turn up the finisher (4) and pry the trim cover
retainers free from the body panel.
635RW001
Installation
To install, follow the removal steps in the reverse order.
8J–24
EXTERIOR/INTERIOR TRIM
Center Pillar Assist Grip
Parts Location
743RS004
Legend
(1) Center Pillar Assist Grip
Removal and Installation
Refer to the Center Pillar and Roof Side Trim Cover in this
section.
Assist Grip
Parts Location
743RS005
Legend
(1) Assist Grip
Removal and Installation
Refer to the Front Pillar Trim Cover in this section.
EXTERIOR/INTERIOR TRIM
8J–25
Fuel Filler Lid Opener Cable
Fuel Filler Lid Opener Cable and Associated Parts
686RW008
Legend
(1) Rear End Floor Trim Cover
(2) Fuel Filler Lid Opener Cable (LWB)
(3) To Lever
(4) Cable
(5) Marking
(6) Clip
(7) To Door
(8) Fuel Filler Lid Opener Cable (SWB)
(9) Chassis Harness
(10) Center Console Assembly
(11) Fuel Filler Lid Opener
(12) Front Seat (RH)
(13) Center Pillar Lower Trim Cover
(14) Rear Door Sill Plate (RH)
(15) Luggage Side Trim Panel (RH)
Removal
1. Disconnect the battery ground cable.
2. Remove the front seat (RH).
3. Remove the rear door sill plate (RH).
4. Remove the center pillar lower trim cover.
5. Remove the rear end floor trim panel.
6. Remove the luggage side trim panel (RH).
D
Refer to the Luggage Side and Quarter Upper Trim
Cover in this section.
8J–26
EXTERIOR/INTERIOR TRIM
7. Remove the fuel filler lid opener(1).
D
Remove two opener fixing screws and disconnect
the cable(2).
686RW007
8. Remove the center console assembly.
9. Remove the fuel filler lid opener cable.
D
Roll up the floor carpet and remove the clips of the
chassis harness and body panel to pull out the
cable toward the fuel filler lid.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Insert the opener cable(2) into the body panel(1)
securely.
686RS002
2. Install the cable and clips to its original position to the
chassis harness and the body panel.
3. Check that the opener operates smoothly.
Fuel Filler Door
Parts Location
686RS003
Legend
(1) Fuel Filler Door
Removal
1. Remove the fuel filler door.
Installation
1. Install the fuel filler door.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст