Opel Frontera UBS. Service manual — part 1925
3D – 12 REAR SUSPENSION; COIL SPRING
LATERAL ROD
1
3
2
Removal Steps
1.
Nut and washer
2.
Bolt and nut
3.
Lateral rod
Installation Steps
3.
Lateral rod
2.
Bolt and nut
1.
Nut and washer
REMOVAL
1. Nut and Washer
2. Bolt and Nut
3. Lateral Rod
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
1. Lateral Rod
460RW027
REAR SUSPENSION; COIL SPRING 3D – 13
2. Rubber Bushing (Axle side)
Remove the rubber bushing (Axle side).
Remover: 5-8840-2327-0 (J-39792)
Install the rubber bushing (Axle side).
Installer: 5-8840-2327-0 (J-39792)
NOTE:
When mounting rubber bushings, do not use grease
on bushings or any other nearby parts.
3. Rubber Bushing (Frame side)
Remove the rubber bushing (Frame side).
Remover: 5-8840-2299-0 (J-39215)
Install the rubber bushing (Frame side).
Installer: 5-8840-2299-0 (J-39215)
NOTE:
When mounting rubber bushings, do not use grease
on bushings or any other nearby parts.
3D – 14 REAR SUSPENSION; COIL SPRING
INSTALLATION
3. Lateral Rod
Make sure that the lateral rod is in its correct position.
NOTE:
When mounting lateral rod, be sure not to use grease
on bushings or any other nearby part.
2. Bolt and Nut
NOTE:
Tighten the bolt and nut lightly, and retighten to the
specified torque after the vehicle is at curb height.
Lateral Rod Nut Torque
N·m (kg·m/lb·ft)
137 (14.0 / 101)
1. Nut and Washer
NOTE:
Tighten the nut lightly, and retighten to the specified
torque after the vehicle is at curb height.
Lateral Rod Nut Torque
N·m (kg·m/lb·ft)
78 (8.0 / 58)
REAR SUSPENSION; COIL SPRING 3D – 15
STABILIZER BAR
1
5
2
4
4
3
3
2
Removal Steps
1.
Nut and washer
2.
Link
3.
Bracket
4.
Rubber bushing
5.
Stabilizer bar
Installation Steps
5.
Stabilizer bar
4.
Rubber bushing
3.
Bracket
2.
Link
1.
Nut and washer
REMOVAL
Preparation:
1)
Raise the vehicle and support the frame with suitable
safety stands.
2)
Remove wheel and tire assembly.
Refer to “Wheels and Tires” in section 3E.
1. Nut and Washer
CAUTION:
Be careful not to break the ball joint boot.
2. Link
3. Bracket
4. Rubber Bushing
5. Stabilizer Bar
460RW028
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст