Opel Frontera UBS. Service manual — part 1751
8F–75
BODY STRUCTURE
5. Remove tailgate fixing bolts.
681RS002
6. Remove tailgate assembly (LH).
7. Remove tailgate hinge.
D
Apply a setting mark (1) on the body side hinge and
remove the hinge fixing bolts.
681RW007
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Apply chassis grease to the tailgate hinge and the
tailgate stopper moving surface.
2. Align the tailgate fitting to the body by referring to
Body Dimension in this section.
3. Tighten the hinge bolts to the specified torque.
Torque : 34 N
•
m (3.5kg·m/25 lb ft)
8F–76
BODY STRUCTURE
Tailgate Assembly (RH)
Parts Location
681RS004
Legend
(1) Tailgate Assembly (RH)
(2) Tailgate Trim Panel (RH)
(3) Tailgate Harness Connection
(4) Rear Combination Light (RH)
(5) Tailgate Fixing Bolt
(6) Tailgate Hinge
Removal
1. Disconnect the battery ground cable.
2. Remove rear combination light (RH).
3. Remove tailgate trim panel (RH).
D
Refer to Tailgate Trim Panel (RH) in Exterior /
Interior section.
4. Remove tailgate harness connection.
D
Disconnect the tailgate harness connection.
810RS004
8F–77
BODY STRUCTURE
5. Remove tailgate fixing bolt.
681RS005
6. Remove tailgate assembly (RH).
7. Remove tailgate hinge.
D
Apply a setting mark (1) on the body side hinge and
remove the hinge fixing bolts.
681RW006
Installation
To install, follow the removal steps in the reverse order,
noting the following point.
1. Apply chassis grease to the tailgate hinge moving
surface.
2. Align the tailgate fitting to the body. Refer to Body
Dimension in this section.
3. Tighten the hinge bolts to the specified torque.
Torque : 34 N
•
m (3.5kg·m/25 lb ft)
8F–78
BODY STRUCTURE
Tailgate Strikers
Adjustment
683RW012
1. Loosen the striker screws (3) (or bolts (2)).
2. Tap the striker (1) with a plastic hammer to align.
3. Tighten the striker screws (3) (or bolts (2)).
Screw Torque : 15 N
•
m (1.5kg·m/11 lb ft)
Bolt Torque : 12 N
•
m (1.2kg·m/104 lb in)
Tailgate Stopper Assembly
Parts Location
683RS010
Legend
(1) Tailgate
(2) Rear Bumper
(3) Tailgate Stopper Assembly
Removal
1. Remove tailgate stopper assembly.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Tighten the fixing bolts to the specified torque.
Torque : 12 N
•
m (1.2kg·m/104 lb in)
2. Apply chassis grease to the stopper moving surface.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст