Opel Frontera UBS. Service manual — part 93
FRONT SUSPENSION 3C – 7
TORSION BAR
Removal Steps
1.
Adjust bolt, end piece and seat
2.
Height control arm
3.
Torsion bar
Installation Steps
3.
Torsion bar
2.
Height control arm
1.
Adjust bolt, end piece and seat
REMOVAL
Preparation:
Raise the vehicle and support the frame with suitable
safety stands.
1. Adjust Bolt, End Piece and Seat
Apply the setting marks to the adjust bolt and end
piece.
3C – 8 FRONT SUSPENSION
2. Height Control Arm
Apply the setting marks to the height control arm and
torsion bar.
3. Torsion Bar
Apply the setting marks to the torsion bar and lower
control arm.
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
Check the following parts:
•
Torsion bar
•
Height control arm
•
Adjust bolt
•
Rubber seat
INSTALLATION
3. Torsion Bar
Make sure the bars are on their correct respective
sides.
Apply grease to the serrated portions.
FRONT SUSPENSION 3C – 9
Align the setting marks.
2. Height Control Arm
Apply grease to the portion that fits into the bracket.
Align the setting marks.
Apply grease to the bolt portion of the end piece.
Apply grease to the portion of the seat that fits into
the bracket.
Apply grease to the serrated portions.
1. Adjust Bolt and Seat
Turn ther adjust bolt to the setting mark applied
during disassembly.
NOTE:
Adjust the trim height. Refer to “Front End Alignment” in
section 3A.
3C – 10 FRONT SUSPENSION
KNUCKLE
Removal Steps
1.
Torsion bar
2.
Wheel speed sensor
(if equipped with ABS)
3.
Back plate
4.
Lower ball joint
5.
Upper ball joint
6.
Knuckle assembly
7.
Oil seal
8.
Thrust washer
9.
Needle bearing
10.
Knuckle
Installation Steps
10.
Knuckle
9.
Needle bearing
8.
Thrust washer
7.
Oil seal
6.
Knuckle assembly
5.
Upper ball joint
4.
Lower ball joint
3.
Back plate
2.
Wheel speed sensor
(if equipped with ABS)
1.
Torsion bar
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст