Opel Frontera UBS. Service manual — part 964
2A – 74 SUPPLEMENTAL RESTRAINT SYSTEM STEERING WHEEL & COLUMN
SYSTEM INSPECTION
Turn the ignition to "ON" while watching warning
light.
Light should flash 7 times and then go off. If lamp
does not operate correctly, refer to Section 9J.
SUPPLEMENTAL RESTRAINT SYSTEM STEERING WHEEL & COLUMN 2A – 75
SECTION 2A
STEERING COLUMN
CONTENTS
PAGE
General Description . . . . . . . . . . . . . . . . . . . . . . . . . . . 2A – 76
On-Vehicle Service. . . . . . . . . . . . . . . . . . . . . . . . . . ... 2A – 77
Steering Wheel Replacement . . . . . . . . . . . . . . . . . . . . . . 2A – 77
Combination Switch Replacement . . . . . . . . . . . . . . . . . . . 2A – 79
Lock Cylinder Replacement . . . . . . . . . . . . . . . . . . . . . . 2A – 81
Steering Column Replacement . . . . . . . . . . . . . . . . . . . . .. 2A – 84
2A – 76 SUPPLEMENTAL RESTRAINT SYSTEM STEERING WHEEL & COLUMN
GENERAL DESCRIPTION
The steering column has three important features in
addition to the steering function:
1.
The column is energy absorbing, designed to
compress in a front-end collision to minimize
the possibility of injury to the driver of the
vehicle.
2.
The ignition switch and lock are mounted
conveniently on the column.
3.
With the column mounted lock, the ignition
and steering operation can be locked to
prevent theft of the vehicle.
The column may be disassembled and
reassembled. To insure the energy absorbing
action, it is important that the specified screws,
bolts and nuts be used only as designated and that
they are tightened to the specified torque.
When the column is removed from the vehicle, a
sharp blow on the end of steering shaft leaning on
the column assembly, or dropping the assembly
could shear or loosen the fasteners that maintain
column rigidity.
SUPPLEMENTAL RESTRAINT SYSTEM STEERING WHEEL & COLUMN 2A – 77
ON-VEHICLE SERVICE
STEERING WHEEL REPLACEMENT
Removal Steps
1. Center pad
2. Nut
3. Steering wheel
Installation Steps
3. Steering wheel
2. Nut
1. Center pad
These steps are based on the LHD model.
REMOVAL
1. Center Pad
1) Remove the center pad attaching screw from the
steering wheel under side.
2) Disconnect the harness.
3) Remove the center pad from the center of the
steering wheel.
2. Nut
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст