Opel Frontera UBS. Service manual — part 897
1A – 14 HEATING AND VENTILATION
Removal Steps
1. Instrument panel assembly
2. Resistor connector
3. Duct
3a. Evaporator assembly (A/C only)
4. Kick panel
5. Blower motor connector
6. Blower assembly
Installation Steps
To install, follow the removal steps in the
reverse order.
BLOWER ASSEMBLY
2
3a(With A/C)
3
Heater unit
Electro thermo connector
(With A/C)
1
4
6
5
This illustration is based on LHD
HEATING AND VENTILATION 1A – 15
REMOVAL
Preparation:
•
Disconnect the battery ground cable
•
Discharge and recover refrigerant (W/A/C)
(Refer to Section 1B “REFRIGERANT RECOVERY”)
1. Instrument Panel Assembly
Refer to Section 10 “BODY” for INSTRUMENT PANEL
ASSEMBLY removal procedure.
2. Resistor Connector
3. Duct
3a. Evaporator Assembly (A/C only)
Refer to Section 1B “AIR CONDITIONING” for
EVAPORATOR ASSEMBLY removal procedure.
4. Kick panel
5. Blower Motor Connector
6. Blower Assembly
INSTALLATION
To install, follow the removal steps in the reverse order,
noting the following point:
1. Adjust Control Lever Assembly Cables
Refer to “CONTROL LEVER ASSEMBLY” installation
procedure in this section.
1A – 16 HEATING AND VENTILATION
Removal Steps
1. Blower assembly
2. Lower case
3. Upper case
4. Mode door
5. Sub-lever
6. Door lever
Installation Steps
To install, follow the removal steps in the
reverse order.
BLOWER LINK UNIT AND/OR MODE DOOR
This illustration is based on LHD
1
3
6
2
4
5
HEATING AND VENTILATION 1A – 17
REMOVAL
Preparation:
Disconnect the battery ground cable
1. Blower Assembly
Refer to “BLOWER ASSEMBLY” removal procedure
in this section.
2. Lower Case
3. Upper Case
Separate upper case and slit the lining parting face
with a knife.
INSTALLATION
To install, follow the removal steps in the reverse order,
noting the following points:
1. Apply grease to the door lever and to the abrasive
surface of the upper case.
2. Apply an adhesive to parting face of lining when
assembling upper case.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст