Subaru BRZ (2012 year). Service manual — part 7
NT-5
Note
NOTE
10.LIFT AND JACK
When using a lift or shop jack to raise a vehicle or
using rigid rack to support a vehicle, always follow
instructions concerning jack-up points and weight
limits to prevent the vehicle from falling, which
could result in injury. Be especially careful that the
vehicle is balanced before raising it. Be sure to set
the wheel stoppers when jacking-up only the front
or rear side of the vehicle.
CAUTION:
Select the lift attachment so that the side sill
does not contact the lift arm.
NOTE:
• When using a lift, follow its operation manual.
• When the side sill cover contacts the lift arm, use
a lift attachment.
• Do not work or leave unattended while the vehi-
cle is supported with jack, support it with rigid
racks.
• Be sure to use the rigid racks with rubber at-
tached to cradle to support the vehicle.
• When using a lift, use an attachment or some-
thing similar.
• When using a plate lift, use a rubber attachment.
Place the attachment to the specified position of
the vehicle, by adjusting front/rear and left/right
sides accordingly.
• Align the cushion rubber center part of plate lift
with the center part of rubber attachment.
• Do not use the plate lift whose attachment does
not reach the supporting locations.
(A) 80 mm (3.1 in) or more
(B) 80 — 100 mm (3.15 — 3.94 in)
(C) 120 — 200 mm (4.72 — 7.87 in)
(A)
(B)
(C)
NT-00070
NT-6
Note
NOTE
• Support locations
• Pantograph jack
CAUTION:
When storing the jack holder after use, store with the jack handle mount of the jack facing the inside
of the trunk.
(1)
Jack-up point
(1)
Jack-up point
NT-00467
(1)
(1)
(1)
NT-00459
(1)
NT-7
Note
NOTE
• Lift
CAUTION:
For models with side under skirt, use a spacer or an attachment to lift up the vehicle securely at jack
up point, without contact of side under skirt and lift.
• Rigid rack
(A)
Attachment
NT-00271
NT-00242
(A)
NT-8
Note
NOTE
• Plate lift
• Jack-up point (When using a garage jack)
CAUTION:
If jacking up the front side of the vehicle, make sure that the jack is attached at the center of the jack-
up plate not at the sides.
(1)
Jack-up point
(2)
Attachment
(A)
Front
(B)
Rear
(1)
Frame
(2)
Rear differential
NT-00452
(2)
(1)
(1)
(2)
(1)
(A)
(B)
NT-00447
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст