Chevrolet Silverado / GMC Sierra. Service manual — part 1432
Fig. 117: Identifying Driveshaft Pinion, Yoke Retainers & Bolts
Courtesy of GENERAL MOTORS CORP.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Reference mark the rear propeller shaft (3) to the rear axle pinion yoke (4).
3. Disconnect the propeller shaft from the axle.
Wrap the bearing caps with tape in order to prevent the loss of bearing rollers. Support the
propeller shaft as necessary.
2008 Chevrolet Silverado 1500
2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 118: Measuring Pinion Rotating Torque
Courtesy of GENERAL MOTORS CORP.
4. Using an inch-pound torque wrench, measure the amount of torque required to rotate the
pinion. Record this measurement for reassembly. This will give the combined preload for
the following components:
The pinion bearings
The pinion oil seal
The differential case bearings
The axle bearings
The axle seals
2008 Chevrolet Silverado 1500
2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 119: View Of Pinion Shaft & Pinion Yoke Alignment Marks
Courtesy of GENERAL MOTORS CORP.
5. Place an alignment mark between the pinion and the pinion yoke.
2008 Chevrolet Silverado 1500
2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 120: Holding Pinion Yoke With Special Tool
Courtesy of GENERAL MOTORS CORP.
6. Install the J 8614-01 as shown.
7. While holding the J 8614-01 , loosen the pinion nut.
8. Remove the washer.
2008 Chevrolet Silverado 1500
2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст