Chevrolet Silverado / GMC Sierra. Service manual — part 2658
DTC B1600 01
Mirror Motor Vertical Circuit Short to Battery
DTC B1600 02
Mirror Motor Vertical Circuit Short to Ground
DTC B1600 04
Mirror Motor Vertical Circuit Open
DTC B1605 01
Mirror Motor Horizontal Circuit Short to Battery
DTC B1605 02
Mirror Motor Horizontal Circuit Short to Ground
DTC B1605 04
Mirror Motor Horizontal Circuit Open
Diagnostic Fault Information
Circuit/System Description
The Driver Door Switch (DDS) or Passenger Door Switch (PDS) controls the mirror horizontal
and vertical motors through the use of bi-directional motor controls. When the mirror is
commanded up, voltage is supplied to the mirror vertical motor through the Driver/Passenger
Mirror Motor Right/Down Motors Common circuit and ground is supplied through the
Circuit
Short to
Ground
Open/High
Resistance
Short to
Voltage
Signal
Performance
Driver/Passenger Mirror Motor
Right Control
B1605 02
B1605 04
B1605 01
-
Driver/Passenger Mirror
Right/Down Motors Common
B1544 02
B1544 04
B1544 01
-
Driver/Passenger Mirror Motor
Down Control
B1600 02
B1600 04
B1600 01
-
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Mirrors - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Driver/Passenger Mirror Motor Down Control circuit. When the mirror is commanded down,
voltage is supplied to the mirror vertical motor through the Driver/Passenger Mirror Motor Down
Control circuit and ground is supplied through the Driver/Passenger Mirror Motor Right/Down
Motors Common circuit.
Horizontal controls operate in the same manner with the Driver/Passenger Mirror Motor
Right/Down Motors Common circuit supplying voltage and the Driver/Passenger Mirror Motor
Right Control circuit supply a ground to the mirror horizontal motor when the mirror is
commanded right. When the mirror is commanded left, voltage is supplied to the mirror
horizontal motor through the Driver/Passenger Mirror Motor Right Control circuit and ground is
supplied through the Driver/Passenger Mirror Motor Right/Down Motors Common circuit.
Conditions for Running the DTC
The power mirror is being commanded left, right, up, or down.
Conditions for Setting the DTC
B1544
An improper voltage level is detected on the Driver/Passenger Mirror Motor Right/Down Motors
Common circuit while the mirror is being commanded.
B1600
An improper voltage level is detected on the Driver/Passenger Mirror Motor Down Control
circuit while the mirror is being commanded.
B1605
An improper voltage level is detected on the Driver/Passenger Mirror Motor Right Control
circuit while the mirror is being commanded.
Action Taken When the DTC Sets
Mirror movement is suspended so long as the fault is present.
Conditions for Clearing the DTC
A current DTC will clear when the fault is no longer present.
A history DTC will clear after 40 malfunction-free ignition cycles.
Reference Information
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Mirrors - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Schematic Reference
Outside Rearview Mirror Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Outside Mirror Description and Operation (Heated Mirrors) or Outside Mirror
Description and Operation (Power Mirrors)
Electrical Information Reference
Circuit Testing
Connector Repairs
Testing for Intermittent Conditions and Poor Connections
Wiring Repairs
Scan Tool References
Control Module References For Scan Tool Information.
Circuit/System Verification
Command the left and right outside mirror to move up, down, left and right using the mirror
directional switch. The mirror should move in the commanded direction.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector X3 at the appropriate door switch.
2. Ignition ON, verify a test lamp does not illuminate between the following control circuit
terminals and ground:
Control circuit terminal 1
Control circuit terminal 2
Control circuit terminal 6
If the test lamp illuminates, test the appropriate control circuit for a short to voltage.
3. Ignition OFF, test for infinite resistance between the following control circuits and ground:
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Mirrors - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Control circuit terminal 1
Control circuit terminal 2
Control circuit terminal 6
If less the specified value, test the appropriate control circuit for a short to ground.
4. Test for 40-100 ohms of resistance between the control circuit terminal 1 and the control
circuit terminal 6.
If not within the specified range, test both control circuit for an open/high resistance. If
the circuits test normal, test or replace the rearview mirror motor.
5. Test for 40-100 ohms of resistance between the control circuit terminal 2 and the control
circuit terminal 6.
If not within the specified range, test both control circuit for an open/high resistance. If
the circuits test normal, test or replace the rearview mirror motor.
6. If all circuits test normal, replace the appropriate door switch.
Repair Procedures
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Outside Rearview Mirror Motor Replacement
Control Module References for DDS or PDS replacement, setup, and programming
DTC B1580 OR B1590
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic approach.
Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptors
DTC B1580
Mirror Horizontal Position Sensor Circuit
DTC B1590
Mirror Vertical Position Sensor Circuit
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Mirrors - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст