Chevrolet Silverado / GMC Sierra. Service manual — part 2338
BLOWER MOTOR REPLACEMENT
Removal Procedure
1. If equipped, remove the sound insulator panel. Refer to Instrument Panel Insulator
Replacement (with RPO SLT) or Instrument Panel Insulator Replacement (without
RPO SLT) .
2. Remove the blower motor insulating cover screws.
3. Disconnect the electrical connector from the blower motor.
4. Remove the blower motor insulating cover.
1
Blower Motor Control Module Screw (Qty: 2)
Tighten: 1.5 N.m (13 lb in)
NOTE:
Refer to Fastener Notice .
2
Blower Motor Control Module
2008 Chevrolet Silverado 1500
2008 HVAC Heating, Ventilation, and Air Conditioning - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra &
Silverado
Fig. 97: Disengaging Blower Motor (Delphi)
Courtesy of GENERAL MOTORS CORP.
5. Pull the retaining tab down while turning the blower motor counterclockwise in order to
disengage the blower motor from the heater/ventilation module.
2008 Chevrolet Silverado 1500
2008 HVAC Heating, Ventilation, and Air Conditioning - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra &
Silverado
Fig. 98: View Of Blower Motor (Delphi)
Courtesy of GENERAL MOTORS CORP.
6. Remove the blower motor.
Installation Procedure
2008 Chevrolet Silverado 1500
2008 HVAC Heating, Ventilation, and Air Conditioning - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra &
Silverado
Fig. 99: View Of Blower Motor (Delphi)
Courtesy of GENERAL MOTORS CORP.
1. Install the blower motor.
2008 Chevrolet Silverado 1500
2008 HVAC Heating, Ventilation, and Air Conditioning - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra &
Silverado
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст