Chevrolet Silverado / GMC Sierra. Service manual — part 2457
Fig. 5: View Of Front Side Door Trim Panel (SLT)
Courtesy of GENERAL MOTORS CORP.
Callout
Component Name
Preliminary Procedure
1. Remove the door upper trim panel. Refer to Upper Extension Trim Panel Replacement.
2. Remove the door window control switch. Refer to Door Lock and Side Window Switch
Replacement - Driver Side and Door Lock and Side Window Switch Replacement - Passenger
Side .
1
Front Side Door Locking Rod Knob Assembly
Tip:
1. Lower the window.
2. Ensure the locking rod is in the unlocked position.
3. Use a flat-bladed tool to disengage the detent tab and then remove the knob by
pulling upward.
4. When re-installing, push the knob down until the detent tab touches the locking rod
opening cover.
5. Push the detent tab in to lock the knob to the locking rod.
2
Front Side Door Trim Panel Cover
3
Front Side Door Trim Panel Cover Retainer (Qty: 3)
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
REAR SIDE DOOR TRIM PANEL REPLACEMENT (YE9)
4
Front Side Door Inside Handle Bezel Cover
5
Front Side Door Trim Panel Bolt (Qty: 3)
Tighten: 2 N.m (18 lb in)
NOTE:
Refer to Fastener Notice .
6
Front Side Door Trim Panel Assembly
Tip:
1. Disconnect the electrical connectors.
2. There are 2 hooks located on the lower portion of the door trim panel that are being
used for manufacturing installation ONLY.
3. If these hooks are damaged during either removal or installation of the door trim
panel, replacement of the panel is not required.
4. When installing the trim panel start at the lock knob, pushing down and outward
moving toward the upper front.
7
Front Side Door Cable Retainer
Tip: Pull upward to disengage.
8
Front Side Door Trim Panel Retainer (Qty: 12)
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
Fig. 6: View Of Rear Side Door Trim Panel (YE9)
Courtesy of GENERAL MOTORS CORP.
Callout
Component Name
Preliminary Procedure
1. Remove the window control switch, if equipped. Refer to Rear Side Door Window Switch
Replacement (Crew Cab) or Rear Side Door Window Switch Replacement (Extended Cab) .
2. Remove the door window regulator handle, if equipped. Refer to Door Window Regulator
Handle Replacement .
1
Rear Side Door Locking Rod Knob Assembly
Procedure
1. Lower window.
2. Ensure locking rod is in the unlocked position.
3. Use a flat-bladed tool to disengage detent tab and then remove knob by pulling
upward.
4. When re-installing, push knob down until detent tab touches locking rod opening
cover.
5. Push detent tab in to lock knob to locking rod.
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
REAR SIDE DOOR TRIM PANEL REPLACEMENT (SLT)
Fig. 7: View Of Rear Side Door Trim Panel (SLT)
Courtesy of GENERAL MOTORS CORP.
2
Rear Side Door Release Handle Cover
3
Rear Side Door Armrest Opening Cover
4
Rear Side Door Trim Panel Bolt (Qty: 3)
Tighten: 2 N.m (18 lb in)
NOTE:
Refer to Fastener Notice .
5
Rear Side Door Trim Panel Assembly
Procedure
1. Disengage door lock cable.
2. There are two hooks located on the lower portion of the door trim panel that are being
used for manufacturing installation ONLY.
3. If these hook are damaged during either removal or installation of the door trim
panel, replacement of the panel is not required.
6
Rear Side Door Trim Panel Retainer (Qty: 10)
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст