Chevrolet Silverado / GMC Sierra. Service manual — part 2884
Fig. 8: Transfer Case Shift Control Module Replacement
Courtesy of GENERAL MOTORS CORP.
TRANSFER CASE SHIELD REPLACEMENT
Callout
Component Name
1
Transfer Case Shift Control Module
Procedure
1. Disconnect the electrical connector.
2. Remove the module from the module bracket by releasing the retaining
tabs.
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Transfer Case - MP 1625/1626-NQF - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra &
Silverado
Fig. 9: Transfer Case Shield Replacement
Courtesy of GENERAL MOTORS CORP.
TRANSFER CASE FLUID REPLACEMENT
Callout
Component Name
Preliminary Procedure:
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
1
Transfer Case Shield Bolt
Tighten: 20 N.m (15 lb ft)
NOTE:
Refer to Fastener Notice .
2
Transfer Case Shield
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Transfer Case - MP 1625/1626-NQF - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra &
Silverado
Fig. 10: Transfer Case Fluid Replacement
Courtesy of GENERAL MOTORS CORP.
Callout
Component Name
Preliminary Procedures
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield
Replacement .
1
Transfer Case Drain Plug
Procedure
1. Allow the transfer case to drain completely.
2. Apply sealant GM P/N 12346004, (Canadian P/N 10953480), or
equivalent, to the plug threads.
Tip: When performing the following procedure, use only hand tools to remove
and install the drain plug.
Tighten: 18 N.m (13 lb ft)
NOTE:
Refer to Component Fastener Tightening Notice .
Transfer Case Fill Plug
Procedure
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Transfer Case - MP 1625/1626-NQF - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra &
Silverado
TRANSFER CASE TWO/FOUR WHEEL DRIVE ACTUATOR REPLACEMENT
Fig. 11: Transfer Case Two/Four Wheel Drive Actuator Replacement
Courtesy of GENERAL MOTORS CORP.
2
1. Fill the transfer case to the bottom of the fill plug hole with DEXRON®
VI GM P/N 88861003 (Canadian P/N 88861004)
2. Apply sealant GM P/N 12346004, (Canadian P/N 10953480), or
equivalent, to the plug threads.
Tip: When performing the following procedure, use only hand tools to remove
and install the fill plug.
Tighten: 18 N.m (13 lb ft)
Callout
Component Name
Preliminary Procedure:
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Two/Four Wheel Drive Actuator Bolt (Qty: 3)
NOTE:
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Transfer Case - MP 1625/1626-NQF - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra &
Silverado
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст