Chevrolet Silverado / GMC Sierra. Service manual — part 2961
Circuit/System Description
The driver door switch (DDS) and passenger door switch (PDS) control the power window
functions through the power window motor up and down control circuits. The door switches
monitor the control circuits for fault conditions when up or down operation is requested prior to
activating the function and during operation.
Conditions for Running the DTC
Battery voltage must be between 9-16 volts.
LR Window Switch B+
1, 3
3
-
-
Passenger Door Switch B+
2, 4
2
-
-
RR Window Switch B+
2, 4
4
-
-
Power Window Switch Right
Rear Down Signal
B3823 00
B3823 00
B3823 00
-
Power Window Switch Right
Rear Up Signal
B3822 00
B3822 00
B3822 00
-
Power Window Switch Left
Rear Down Signal
B3820 00
B3820 00
B3820 00
-
Power Window Switch Left
Rear Up Signal
B3819 00
B3819 00
B3819 00
-
Power Window Lockout Left
Rear Control
B3821 00
B3821 00
B3821 00
-
Power Window Lockout Right
Rear Control
B3824 00
B3824 00
B3824 00
-
LR Window Motor Control
3
3
3
-
Passenger Window Motor
Control
B3205 00
B3205 0B
B3205 00
-
RR Window Motor Control
4
4
4
-
Driver Window Motor
Control
B3205 00
B3205 0B
B3205 00
-
LR Window Switch Ground
-
3
3
-
RR Window Switch Ground
-
4
4
-
1. Driver Window Malfunction
2. Passenger Window Malfunction
3. Left Rear Window Malfunction
4. Right Rear Window Malfunction
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
The ignition switch is in the ON position.
Conditions for Setting the DTC
B3205 00
The DDS or PDS detects a short to ground or short to voltage on their respective window motor
control circuit.
B3205 0B
The DDS or PDS has detected excessive current flow on their respective window motor control
circuit.
Action Taken When the DTC Sets
The affected power window will be inoperative.
Conditions for Clearing the DTC
The DTC will be current for as long as the fault is present.
When the fault is no longer present, the DTC will be a history DTC.
A history DTC will clear after 50 ignition cycles.
Diagnostic Aids
The DTC can be set due to excessive physical resistance in the window regulator assembly.
Ensure proper mechanical operation of the regulator assembly prior to replacing electrical
components.
Reference Information
Schematic Reference
Moveable Window Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Power Windows Description and Operation
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
Electrical Information Reference
Circuit Testing
Connector Repairs
Testing for Intermittent Conditions and Poor Connections
Wiring Repairs
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Igntition ON, bserve the operation of the power windows while commanding each window UP
and DOWN by using their respective window switches, each window should perform the UP and
DOWN function.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the appropriate window motor.
2. Connect a test lamp between control circuit terminal A and control circuit terminal B.
3. Ignition ON, command the appropriate window UP and DOWN by using the respective
window switch. The test lamp should turn ON when commanding the UP and DOWN states.
If the test lamp is always OFF during either of the commands, test for a short to ground
or open/high resistance on either control circuit. If the circuits test normal, replace the
appropriate door switch.
If the test lamp is always ON, test for a short to voltage on either control circuit. If the
circuits test normal, replace the appropriate door switch.
4. If all circuits test normal, test or replace the appropriate window motor.
Component Testing
1. Ignition OFF, disconnect the harness connector at the appropriate window motor.
2. Ignition ON, install a 25 amp fused jumper wire between the control terminal A and 12
volts. Momentarily install a jumper wire between the control terminal B and ground. The
appropriate window motor should perform the UP function.
If the function does not perform as specified, replace the appropriate window motor.
3. Reverse the jumper wires; the appropriate window motor should perform the DOWN
function.
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
If the function does not perform as specified, replace the appropriate window motor.
Repair Procedures
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for DDS and PDS replacement, setup and programming.
Front Side Door Window Regulator Motor Replacement
DTC B3819, B3820, B3822, OR B3823
Diagnostic Instructions
Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
Review Strategy Based Diagnosis for an overview of the diagnostic approach.
Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptors
DTC B3819 00
Left Rear Window Up Control Circuit
DTC B3820 00
Left Rear Window Down Control Circuit
DTC B3822 00
Right Rear Window Up Control Circuit
DTC B3823 00
Right Rear Window Down Control Circuit
Diagnostic Fault Information
Circuit
Short to
Ground
Open/High
Resistance
Short to
Voltage
Signal
Performance
Driver Door Switch B+
U0199 00
U0199 00
-
-
LR Window Switch B+
1, 3
3
-
-
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Fixed and Moveable Windows - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст