Chevrolet Silverado / GMC Sierra. Service manual — part 1206
Fig. 24: Halfshaft Seal Cover & CV Joint
Courtesy of GENERAL MOTORS CORP.
8. Twist the halfshaft seal cover (1) until the middle of the cover fits loosley against the
halfshaft bar.
9. Position the outboard end of the halfshaft seal cover (1) over the CV joint (2) flat.
2008 Chevrolet Silverado 1500
2008 DRIVELINE/AXLE Wheel Drive Shafts - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 25: Tightening Seal Cover Clamp
Courtesy of GENERAL MOTORS CORP.
10. Use J 41187 in order to tighten the outboard cover clamp (1). See Special Tools.
IMPORTANT: Tighten the seal cover clamp (1) as tight as possible without
deforming the retaining clip. Clamps that are not tight
enough allow the cover to slide upon the joint. This causes
shortened service life.
2008 Chevrolet Silverado 1500
2008 DRIVELINE/AXLE Wheel Drive Shafts - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 26: Bending Outboard Band Onto Clip
Courtesy of GENERAL MOTORS CORP.
11. Rotate J 41187 toward the clip in order to bend the band onto the clip. See Special Tools.
12. Pull the tool's cutting handle in order to cut off the excess band.
2008 Chevrolet Silverado 1500
2008 DRIVELINE/AXLE Wheel Drive Shafts - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 27: Pounding Outboard Band Flat
Courtesy of GENERAL MOTORS CORP.
13. Pound the band flat between the latch tabs. Peen the latch tabs over in order to lock the
band into position.
2008 Chevrolet Silverado 1500
2008 DRIVELINE/AXLE Wheel Drive Shafts - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст