Chevrolet Silverado / GMC Sierra. Service manual — part 2601
Fig. 23: Identifying VSS And O-Ring Seal
Courtesy of GENERAL MOTORS CORP.
1. Coat a NEW O-ring seal with a thin film of Synchro-mesh transmission fluid GM P/N
12345349 (Canadian P/N 10953465), or equivalent.
2. Install the VSS and O-ring seal.
Tighten: Tighten the VSS to 16 N.m (12 lb ft).
NOTE:
Refer to Component Fastener Tightening Notice .
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (TZ0)
Fig. 24: Locating HO2S Electrical Connector At Harness (Manual 2WD)
Courtesy of GENERAL MOTORS CORP.
3. Connect the VSS electrical connector (1).
4. Lower the vehicle.
TRANSMISSION FLUID REPLACEMENT
Tools Required
J 36511 Oil Fill/Drain Plug Hex Bit (17 mm)
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (TZ0)
Removal Procedure
Fig. 25: View Of Oil Fill Plug
Courtesy of GENERAL MOTORS CORP.
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Using J 36511 remove the oil fill plug.
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (TZ0)
Fig. 26: View Of Oil Drain Plug
Courtesy of GENERAL MOTORS CORP.
3. Place a suitable drain pan under the transmission in order to catch the drained transmission
fluid.
4. Using J 36511 remove the oil drain plug.
5. Remove any old sealant from the transmission housing.
Installation Procedure
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Manual Transmission - Tremec 5-Speed (TZ0)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст