Chevrolet Silverado / GMC Sierra. Service manual — part 2446
Fig. 6: View Of Rear Side Door Trim Panel (YE9)
Courtesy of GENERAL MOTORS CORP.
Callout
Component Name
Preliminary Procedure
1. Remove the window control switch, if equipped. Refer to Rear Side Door Window
Switch Replacement (Crew Cab) or Rear Side Door Window Switch
Replacement (Extended Cab) .
2. Remove the door window regulator handle, if equipped. Refer to Door Window
Regulator Handle Replacement .
1
Rear Side Door Locking Rod Knob Assembly
Procedure
1. Lower window.
2. Ensure locking rod is in the unlocked position.
3. Use a flat-bladed tool to disengage detent tab and then remove knob by
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
REAR SIDE DOOR TRIM PANEL REPLACEMENT (SLT)
pulling upward.
4. When re-installing, push knob down until detent tab touches locking rod
opening cover.
5. Push detent tab in to lock knob to locking rod.
2
Rear Side Door Release Handle Cover
3
Rear Side Door Armrest Opening Cover
4
Rear Side Door Trim Panel Bolt (Qty: 3)
Tighten: 2 N.m (18 lb in)
NOTE:
Refer to Fastener Notice .
5
Rear Side Door Trim Panel Assembly
Procedure
1. Disengage door lock cable.
2. There are two hooks located on the lower portion of the door trim panel
that are being used for manufacturing installation ONLY.
3. If these hook are damaged during either removal or installation of the door
trim panel, replacement of the panel is not required.
6
Rear Side Door Trim Panel Retainer (Qty: 10)
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
Fig. 7: View Of Rear Side Door Trim Panel (SLT)
Courtesy of GENERAL MOTORS CORP.
Callout
Component Name
Preliminary Procedure:
Remove rear door window control switch. Refer to Rear Side Door Window Switch
Replacement (Crew Cab) or Rear Side Door Window Switch Replacement
(Extended Cab) .
1
Rear Side Door Locking Rod Knob Assembly
Procedure
1. Lower the window.
2. Ensure the locking rod is in the unlocked position.
3. Use a flat-bladed tool to disengage detent tab, then remove knob by
pulling upward.
4. When re-installing, push the knob down, until the detent tab touches
locking rod opening cover.
5. Push the detent tab in to lock knob to locking rod.
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
REAR SIDE ACCESS DOOR TRIM PANEL REPLACEMENT
Fig. 8: View Of Rear Side Access Door Trim Panel
Courtesy of GENERAL MOTORS CORP.
2
Rear Side Door Trim Panel Cover
3
Rear Side Door Trim Panel Cover Retainer (Qty: 4)
4
Rear Side Door Inside Handle Bezel Cover
5
Rear Side Door Trim Panel Bolt (Qty: 3)
Tighten: 2 N.m (18 lb in)
NOTE:
Refer to Fastener Notice .
6
Rear Side Door Trim Panel Assembly
7
Rear Side Door Cable Retainer
Tip: Pull upward to disengage.
8
Rear Side Door Trim Panel Retainer (Qty: 10)
2008 Chevrolet Silverado 1500
2008 ACCESSORIES & EQUIPMENT Interior Trim and Paneling - Cab & Chassis Sierra, Cab & Chassis Silverado,
Sierra & Silverado
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст