Chevrolet Silverado / GMC Sierra. Service manual — part 1259
CLUTCH VIBRATION
Replacement.
Clutch disc worn too thin
Replace the clutch assembly. Refer to Clutch
Assembly Replacement.
Cause
Action
DEFINITION: Vibration from the clutch components during disengagement or engagement.
Review the Symptoms - Clutch and perform the necessary inspections.
Excessive driveline torsional activity
Review the Vibration Analysis - Driveline .
Clutch incorrectly installed
Remove the clutch and install it correctly.
Refer to Clutch Assembly Replacement.
Pilot bearing worn or damaged
1. Replace the pilot bearing. Refer to
Clutch Pilot Bearing Replacement.
2. Inspect the input shaft pilot bearing
journal for wear or damage.
3. Replace the input shaft if it is damaged
or worn. Refer to Transmission
Disassemble for the Tremec 5-Speed
(M96) or Transmission Disassemble
for the Tremec 5-Speed (TZO).
Transmission input shaft splines worn or
damaged
1. Inspect the clutch disc to input splines
for wear or damage.
2. Replace the input shaft if the splines are
excessively worn. Refer to
Transmission Disassemble for the
Tremec 5-Speed (M96) or
Transmission Disassemble for the
Tremec 5-Speed (TZO).
Clutch disc facings damaged
Replace the clutch assembly. Refer to Clutch
Assembly Replacement.
Flywheel housing to clutch housing
excessively misaligned
Replace the faulty clutch housing or
transmission front case. Refer to
Transmission Disassemble for the Tremec
5-Speed (M96) or Transmission
Disassemble for the Tremec 5-Speed (TZO).
Clutch out of balance
Replace the clutch assembly. Refer to Clutch
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Clutch - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
REPAIR INSTRUCTIONS
CLUTCH PEDAL REPLACEMENT
Removal Procedure
1. Move the instrument panel to the service position. Refer to Instrument Panel Service
Positioning (Without SLT) or Instrument Panel Service Positioning (With SLT) .
Assembly Replacement.
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Clutch - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 1: Clutch Pedal Position Switch Electrical Connector
Courtesy of GENERAL MOTORS CORP.
2. Disconnect the clutch pedal engine start switch electrical connector (1).
3. Remove the clutch master cylinder. Refer to Clutch Master Cylinder Replacement.
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Clutch - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 2: Clutch Pedal Bracket Assembly
Courtesy of GENERAL MOTORS CORP.
4. Remove the clutch pedal to clutch pedal bracket bolt.
2008 Chevrolet Silverado 1500
2008 TRANSMISSION Clutch - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст