Chevrolet Silverado / GMC Sierra. Service manual — part 1347
Fig. 96: Remove Upper Differential Carrier Assembly Bushing Using J 36616-2, J
33791-1, Thrust Bearing, J 21474-18 & Forcing Screw
Courtesy of GENERAL MOTORS CORP.
2. Remove the upper differential carrier assembly bushing by performing the following steps:
1. Install the J 36616-2 (1), the J 33791-1 (2), the thrust bearing (3), the J 21474-18 (4),
and the forcing screw as shown.
2. Remove the upper differential carrier assembly bushing by holding the forcing screw
and slowly tightening the J 21474-18.
2008 Chevrolet Silverado 1500
2008 Driveline/Axle Front Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 97: Removing Lower Differential Carrier Assembly Bushingj 21474-18, Thrust
Bearing, J 33791-1, J 36616-2, & Forcing Screw
Courtesy of GENERAL MOTORS CORP.
3. Remove the lower differential carrier assembly bushing by performing the following steps:
1. Install the J 21474-18 (1), the thrust bearing (2), the J 33791-1 (3), the J 36616-2 (4),
and the forcing screw as shown.
2. Remove the lower differential carrier assembly bushing by holding the forcing screw
and slowly tightening the J 21474-18.
Installation Procedure
2008 Chevrolet Silverado 1500
2008 Driveline/Axle Front Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 98: Installing Lower Differential Carrier Assembly Bushing Using J 21474-18,
Thrust Bearing, J 36616-2, J 36616-1, & Forcing Screw
Courtesy of GENERAL MOTORS CORP.
1. Install the lower differential carrier assembly bushing by performing the following steps:
1. Install the J 21474-18 (1), the thrust bearing (2), the J 36616-2 (3), the J 36616-1 (4),
and the forcing screw (5) as shown.
2. While holding the forcing screw, slowly tighten the J 21474-18 until the bushing has
stopped against the step on the bushing and is centered within the differential carrier
assembly bushing bore.
2008 Chevrolet Silverado 1500
2008 Driveline/Axle Front Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Fig. 99: Installing Upper Differential Carrier Assembly Bushing J 21474-18, Thrust
Bearing, J 36616-2, J 36616-1, & Forcing Screw
Courtesy of GENERAL MOTORS CORP.
2. Install the upper differential carrier assembly bushing by performing the following steps:
1. Install the J 21474-18 (1), the thrust bearing (2), the J 36616-2 (3), the J 36616-1 (4),
and the forcing screw (5) as shown.
2. While holding the forcing screw, slowly tighten the J 21474-18 until the bushing has
stopped against the step on the bushing and is centered within the differential carrier
assembly bushing bore.
3. Install the differential carrier assembly. Refer to Differential Carrier Assembly
Replacement (1500 FWD) or Differential Carrier Assembly Replacement (2500
2008 Chevrolet Silverado 1500
2008 Driveline/Axle Front Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст