Peugeot 4C (2015 year). Manual — part 19
FUSES
WARNING!
• When replacing a blown fuse, always use an ap-
propriate replacement fuse with the same amp
rating as the original fuse. Never replace a fuse
with another fuse of higher amp rating. Never
replace a blown fuse with metal wires or any other
material. Failure to use proper fuses may result in
serious personal injury, fire and/or property dam-
age.
• Before replacing a fuse, make sure that the ignition
is off and that all the other services are switched off
and/or disengaged.
• If the replaced fuse blows again, contact an autho-
rized dealer.
(Continued)
WARNING! (Continued)
• If a general protection fuse for safety systems (air
bag system, braking system), power unit systems
(engine system, gearbox system) or steering system
blows, contact an authorized dealer.
7
MAINTAINING YOUR VEHICLE
287
Engine Compartment Fuses
The engine compartment fuse box is located on the left
side of the engine compartment, next to the battery. To
access the fuses, remove screws and then remove the
cover.
The ID number of the electrical component correspond-
ing to each fuse can be found on the back of the cover.
Engine Compartment Fuse Box
1 — Forward Screw
2 — Fuse Box Cover
3 — Rearward Screw
288
MAINTAINING YOUR VEHICLE
Cavity
Maxi Fuse
Mini Fuse
Description
F01
70 Amp Tan
Body Controller
F03
20 Amp Yellow
Ignition Switch
F04
40 Amp Orange
Anti-Lock Brake Pump
F05
20 Amp Yellow
Anti-Lock Brake Valve
F06
40 Amp Orange
Radiator Fan - Low Speed
F07
50 Amp Red
Radiator Fan - High Speed
F08
20 Amp Yellow
Blower Motor
F09
5 Amp Tan
Headlight beam switch (If Equipped)
F10
10 Amp Red
Horn
F11
20 Amp Yellow
Powertrain
F14
15 Amp Blue
Alfa Twin Clutch Transmission
F15
15 Amp Blue
Alfa Twin Clutch Transmission
F16
5 Amp Tan
Alfa Twin Clutch Transmission, ECM
F17
10 Amp Red
Powertrain
F18
5 Amp Tan
Powertrain
7
MAINTAINING YOUR VEHICLE
289
Cavity
Maxi Fuse
Mini Fuse
Description
F19
7.5 Amp Brown
Air Conditioning Compressor
F21
20 Amp Yellow
Fuel Pump
F22
20 Amp Yellow
Engine Control Unit Power Supply
F24
5 Amp Tan
Anti-Lock Brake System (ABS)
F30
10 Amp Red
Water Pump, HVAC
F82
30 Amp Green
Headlamp Washer (If Equipped)
F83
40 Amp Orange
Alfa Twin Clutch Transmission Pump
F84
5 Amp Tan
After Run Pump
F86
15 Amp Blue
Rear Power Outlet 12V
F88
7.5 Amp Brown
Heated Mirrors
Dashboard Fuse Box
The dashboard fuse box is part of the Body Control
Module (BCM) and is located on the passenger side
under the forward passenger floor. Remove the six
screws and the forward floor pan to access the BCM.
290
MAINTAINING YOUR VEHICLE
Cavity
Vehicle Fuse
Number
Mini Fuse
Description
3
F53
7.5 Amp Brown
Instrument Panel Node
4
F38
15 Amp Blue
Central Door Locking
5
F36
10 Amp Red
Diagnostic Socket, Car Radio, TPMS, Alarm
6
F43
20 Amp Yellow
Bi-Directional Washer
7
F48
20 Amp Yellow
Passenger Power Window
9
F50
7.5 Amp Brown
Airbag
10
F51
7.5 Amp Brown
Headlamp Washer Relay, A/C Compressor Relay,
High Beam Relay, Parking ECU, Car Radio, Stop
Lamp Switch
11
F37
7.5 Amp Brown
Stop Light Switch, Instrument Panel Node
12
F49
5 Amp Tan
Transmission Shifter Module, Cigar Lighter Light,
Drive Style Unit, Heated Mirrors Relay
13
F31
5 Amp Tan
Climate Control, Body Controller
14
F47
20 Amp Yellow
Driver Power Window
7
MAINTAINING YOUR VEHICLE
291
VEHICLE STORAGE
If you are leaving your vehicle dormant for more than 21
days, you may want to take these steps to protect your
battery.
• Disconnect the negative cable from the battery.
• Anytime you store your vehicle, or keep it out of
service (e.g., vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
REPLACEMENT BULBS
Interior Bulbs
Bulb Number
Overhead Lamp
C10W
Luggage Compartment
W5W
Exterior Bulbs
Bulb Number
Parking Lights/Daytime
Running Lights (DRL)
LED (See Authorized
dealer)
Rear Tail Lights
LED (See Authorized
dealer)
Font and Rear Side
Lights
W3W
292
MAINTAINING YOUR VEHICLE
Bulb Number
Dipped/Main Beam
Headlights (Versions
With Bi-Halogen Head-
lights) — If Equipped
HIR2
Dipped/Main Beam
Headlights (Versions
With Bi-Xenon Head-
lights) — If Equipped
D5S (See Authorized
dealer)
Dipped/Main Beam
Headlights (Versions
With Bi-Led Headlights)
— If Equipped
LED (See Authorized
dealer)
Front Direction Indicators
PY24W
Rear Direction Indicators
P21W
Side Direction Indicators
WY5W
Bulb Number
Brake Lights
LED (See Authorized
dealer)
Third Brake Light
LED (See Authorized
dealer)
License Plate Lamps
W5W
Reversing light
W16W
NOTE:
Numbers refer to commercial bulb types that
can be purchased from your authorized dealer.
If a bulb needs to be replaced, visit your authorized
dealer or refer to the applicable Service Manual.
7
MAINTAINING YOUR VEHICLE
293
BULB REPLACEMENT
NOTE:
Lens fogging can occur under certain atmo-
spheric conditions. This will usually clear as atmospheric
conditions change to allow the condensation to change
back into a vapor. Turning the lamps on will usually
accelerate the clearing process.
Front Light Clusters
The front head lamp contains bulbs for the parking
lights/daytime running lights (DRL), low beam head-
lights, high beam headlights and direction indicators.
If bulb replacement is required, please see an authorized
dealer.
1 — Daytime Running Lights
2 — Direction Indicator
3 — High/Low Beam Lights
294
MAINTAINING YOUR VEHICLE
Side Lights/Daytime Running Lights (DRL)
These are LEDs. For the replacement, contact the your
authorized dealer.
Low/High Beam Bi-Halogen Headlights
To change the bulb, proceed as follows:
1. Turn the steering wheel completely.
2. Open the protective flap by rotating the screw.
1 — Direction Indicator Bulb Protective Flap
2 — Headlamp Bulb Protective Flap
7
MAINTAINING YOUR VEHICLE
295
3. Remove the electric connector (1) and then rotate the
bulb holder (2) clockwise and remove it.
4. Extract the bulb and replace it.
5. Refit the new bulb, making sure that it is locked
correctly, and reconnect the electrical connector.
6. Close the protective flap.
Low/High Beam HID & LED Headlights
For the replacement, contact the your authorized dealer.
Direction Indicators
Front:
1. Turn the steering wheel completely.
2. Open the protective flap by rotating the screw.
1 — Electrical Connector
2 — Bulb Holder
296
MAINTAINING YOUR VEHICLE
3. Rotate the bulb holder counterclockwise and remove
it.
4. Rotate the bulb assembly counter clockwise to remove
from bulb holder.
5. Install the new bulb, making sure that it is locked in
correctly, and reinstall into headlamp assembly.
6. Close the protective flap.
1 — Direction Indicator Bulb Protective Flap
2 — Headlamp Bulb Protective Flap
Bulb Holder
7
MAINTAINING YOUR VEHICLE
297
Side:
1. Adjust the lens in the point shown in to compress the
retaining clip, then pull the cluster outwards.
2. Turn the bulb holder counterclockwise, remove the
bulb and replace it.
3. Install the bulb holder in the lens and turn it clock-
wise.
4. Install the cluster making sure that the internal clip
clicks into position.
1 — Lens
2 — Bulb Holder
298
MAINTAINING YOUR VEHICLE
Front Side Marker
To change the bulb, proceed as follows:
1. Turn the front wheels to gain access and then remove
the fastener from the inner wheel liner.
2. Fold back wheel liner door to access bulb housing.
Fastener Location
Bulb Housing Location
7
MAINTAINING YOUR VEHICLE
299
3. Remove bulb from bulb housing then remove and
replace bulb and reinstall.
Rear Light Clusters
These contain the bulbs for the side lights, direction
indicators and brake lights.
Direction Indicators
To change the bulb, proceed as follows:
1. Remove the protective cap (one for each side) on the
side cover of the luggage compartment.
Front Side Marker Bulb
First Protective Cap
300
MAINTAINING YOUR VEHICLE
2. Remove the second protective cap inserting a hand
inside the opening.
3. Rotate clockwise to remove the bulb holder remove
the bulb from the bulb holder.
4. Install the bulb by pressing it into bulb holder then
turn install the bulb holder and turn it counterclock-
wise.
5. Install the previously removed protective caps.
Tail Lights/Brake Lights
These are LEDs. For the replacement, contact the your
local dealer.
Reversing Light
WARNING!
The reversing light are located close to the exhaust
pipes; take the utmost care not to get burnt during
the bulb replacement.
Second Protective Cap
7
MAINTAINING YOUR VEHICLE
301
To replace the reversing lights turn the bulb holder
counterclockwise, remove the bulb and replace it.
Third Brake Lights
These are LEDs. For the replacement, contact your local
dealer.
1 — Reverse Light Location
2 — Reverse Light Location
Reversing Light Bulb Holder
302
MAINTAINING YOUR VEHICLE
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст