Nissan Pathfinder (2005 year). Instruction — part 375
ELECTRICAL UNITS LOCATION
PG-69
C
D
E
F
G
H
I
J
L
M
A
B
PG
2005 Pathfinder
WKIA3595E
PG-70
ELECTRICAL UNITS LOCATION
2005 Pathfinder
Fuse
EKS009XO
●
If fuse is blown, be sure to eliminate cause of incident before
installing new fuse.
●
Use fuse of specified rating. Never use fuse of more than speci-
fied rating.
●
Do not partially install fuse; always insert it into fuse holder prop-
erly.
●
Remove fuse for “ELECTRICAL PARTS (BAT)” if vehicle is not
used for a long period of time.
Fusible Link
EKS009XP
A melted fusible link can be detected either by visual inspection or by feeling with finger tip. If its condition is
questionable, use circuit tester or test lamp.
CAUTION:
●
If fusible link should melt, it is possible that critical circuit (power supply or large current carrying
circuit) is shorted. In such a case, carefully check and eliminate cause of incident.
●
Never wrap outside of fusible link with vinyl tape.
●
Never let fusible link touch any other wiring harness, vinyl or rubber parts.
Circuit Breaker (Built Into BCM)
EKS009XQ
For example, when current is 30A, the circuit is broken within 8 to 20
seconds.
A circuit breaker is used for the following systems:
●
Power seat
●
Power windows
●
Power door locks
●
Remote keyless entry system
●
Power sunroof
CEL083
SBF284E
HARNESS CONNECTOR
PG-71
C
D
E
F
G
H
I
J
L
M
A
B
PG
2005 Pathfinder
HARNESS CONNECTOR
PFP:B4341
Description
EKS009XR
HARNESS CONNECTOR (TAB-LOCKING TYPE)
●
The tab-locking type connectors help prevent accidental looseness or disconnection.
●
The tab-locking type connectors are disconnected by pushing or lifting the locking tab(s). Refer to the
illustration below.
Refer to the next page for description of the slide-locking type connector.
CAUTION:
Do not pull the harness or wires when disconnecting the connector.
[Example]
SEL769DA
PG-72
HARNESS CONNECTOR
2005 Pathfinder
HARNESS CONNECTOR (SLIDE-LOCKING TYPE)
●
A new style slide-locking type connector is used on certain systems and components, especially those
related to OBD.
●
The slide-locking type connectors help prevent incomplete locking and accidental looseness or discon-
nection.
●
The slide-locking type connectors are disconnected by pushing or pulling the slider. Refer to the illustra-
tion below.
CAUTION:
●
Do not pull the harness or wires when disconnecting the connector.
●
Be careful not to damage the connector support bracket when disconnecting the connector.
[Example]
AEL299C
HARNESS CONNECTOR
PG-73
C
D
E
F
G
H
I
J
L
M
A
B
PG
2005 Pathfinder
HARNESS CONNECTOR (DIRECT-CONNECT SRS COMPONENT TYPE)
●
SRS direct-connect type harness connectors are used on certain SRS components such as air bag mod-
ules and seat belt pre-tensioners.
●
Always pull up to release black locking tab prior to removing connector from SRS component.
●
Always push down to lock black locking tab after installing connector to SRS component. When locked,
the black locking tab is level with the connector housing.
CAUTION:
●
Do not pull the harness or wires when removing connectors
from SRS components.
WHIA0103E
PG-74
ELECTRICAL UNITS
2005 Pathfinder
ELECTRICAL UNITS
PFP:23710
Terminal Arrangement
EKS009XS
WKIA3589E
STANDARDIZED RELAY
PG-75
C
D
E
F
G
H
I
J
L
M
A
B
PG
2005 Pathfinder
STANDARDIZED RELAY
PFP:25230
Description
EKS009XT
NORMAL OPEN, NORMAL CLOSED AND MIXED TYPE RELAYS
Relays can mainly be divided into three types: normal open, normal closed and mixed type relays.
TYPE OF STANDARDIZED RELAYS
SEL881H
SEL882H
1M
1 Make
2M
2 Make
1T
1 Transfer
1M·1B
1 Make 1 Break
PG-76
STANDARDIZED RELAY
2005 Pathfinder
WKIA0253E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст