Nissan Pathfinder (2005 year). Instruction — part 47
LUBRICANT
ATC-23
C
D
E
F
G
H
I
K
L
M
A
B
ATC
2005 Pathfinder
7.
Measure an amount of new lubricant installed equal to amount drained from “old” compressor. Add this
lubricant to “new” compressor through the suction port opening.
8.
Measure an amount of new lubricant equal to the amount recovered during discharging. Add this lubricant
to “new” compressor through the suction port opening.
9.
If the liquid tank also needs to be replaced, add an additional 5 m
(0.2 US fl oz, 0.2 Imp fl oz) of lubricant
at this time.
Do not add this 5 m
(0.2 US fl oz, 0.2 Imp fl oz) of lubricant if only replacing the compressor.
RHA065DD
ATC-24
AIR CONDITIONER CONTROL
2005 Pathfinder
AIR CONDITIONER CONTROL
PFP:27500
Description
EJS003R0
The front air control provides automatic regulation of the vehicle's interior temperature. The system is based
on the driver's and passenger's selected "set temperature", regardless of the outside temperature changes.
This is done by utilizing a microcomputer, also referred to as the front air control, which receives input signals
from the following six sensors:
●
Ambient sensor
●
In-vehicle sensor
●
Intake sensor
●
Optical sensor (one sensor for driver and passenger side)
●
PBR (Position Balanced Resistor).
●
Vehicle speed sensor
The front air control uses these signals (including the set temperature) to automatically control:
●
Outlet air volume
●
Air temperature
●
Air distribution
The front air control also provides separate regulation of the vehicle's interior temperature for the rear passen-
ger area. The system is based on the temperature and rear blower settings selected from rear control
switches located on the front air control, or from the temperature and rear blower settings selected from rear
control switches on the rear air control, when the front air control switches are set to the rear position.
The front air control is used to select:
●
Outlet air volume
●
Air temperature/distribution
Operation
EJS003R1
AIR MIX DOORS CONTROL
The air mix doors are automatically controlled so that in-vehicle temperature is maintained at a predetermined
value by the temperature setting, ambient temperature, in-vehicle temperature and amount of sunload.
BLOWER SPEED CONTROL
Blower speed is automatically controlled by the temperature setting, ambient temperature, in-vehicle tempera-
ture, intake temperature, amount of sunload and air mix door position.
When AUTO switch is pressed, the blower motor starts to gradually increase air flow volume (if required).
When engine coolant temperature is low, the blower motor operation is delayed to prevent cool air from flow-
ing.
INTAKE DOOR CONTROL
The intake door is automatically controlled by the temperature setting, ambient temperature, in-vehicle tem-
perature, intake temperature, amount of sunload and the ON-OFF operation of the compressor.
MODE DOOR CONTROL
The mode door is automatically controlled by the temperature setting, ambient temperature, in-vehicle temper-
ature, intake temperature and amount of sunload.
DEFROSTER DOOR CONTROL
The defroster door is controlled by: Turning the defroster dial to front defroster.
AIR CONDITIONER CONTROL
ATC-25
C
D
E
F
G
H
I
K
L
M
A
B
ATC
2005 Pathfinder
MAGNET CLUTCH CONTROL
When A/C switch or DEF switch is pressed, front air control inputs compressor ON signal to BCM.
BCM sends compressor ON signal to ECM, via CAN communication line.
ECM judges whether compressor can be turned ON, based on each sensor status (refrigerant pressure sen-
sor signal, throttle angle sensor, etc.). If it judges compressor can be turned ON, it sends compressor ON sig-
nal to IPDM E/R, via CAN communication line.
Upon receipt of compressor ON signal from ECM, IPDM E/R turns air conditioner relay ON to operate com-
pressor.
SELF-DIAGNOSTIC SYSTEM
The self-diagnostic system is built into the front air control to quickly locate the cause of symptoms. Refer to
ATC-50, "A/C System Self-diagnosis Function"
.
WJIA1163E
ATC-26
AIR CONDITIONER CONTROL
2005 Pathfinder
Description of Control System
EJS003QY
The control system consists of input sensors, switches, the front air control (microcomputer) and outputs.
The relationship of these components is shown in the figure below:
Control Operation
EJS003QZ
Front air control
WJIA1279E
WJIA1038E
AIR CONDITIONER CONTROL
ATC-27
C
D
E
F
G
H
I
K
L
M
A
B
ATC
2005 Pathfinder
DISPLAY SCREEN
Displays the operational status of the system.
AUTO SWITCH
●
The compressor, intake door, air mix doors, outlet doors and blower speed are automatically controlled so
that the in-vehicle temperature will reach, and be maintained at the set temperature selected by the oper-
ator.
●
When pressing AUTO switch, air inlet, air outlet, blower speed, and discharge air temperature are auto-
matically controlled.
TEMPERATURE CONTROL DIAL (TEMPERATURE CONTROL) (DRIVER SIDE)
Increases or decreases the set temperature.
TEMPERATURE CONTROL DIAL (TEMPERATURE CONTROL) (PASSENGER SIDE)
Increases or decreases the set temperature.
TEMPERATURE CONTROL DIAL (TEMPERATURE AND MODE CONTROL) (REAR)
Increases or decreases the set temperature. The mode also changes from foot at full hot setting, to foot/vent
mid-range (warm) setting, and then to vent on full cold setting.
RECIRCULATION () SWITCH
●
When REC switch is ON, REC switch indicator turns ON, and air inlet is set to REC.
●
When REC switch is turned OFF, or when compressor is turned from ON to OFF, REC switch is automati-
cally turned OFF. REC mode can be re-entered by pressing REC switch again.
●
REC switch is not operated when DEF switch is turned ON, or at the D/F position.
DEFROSTER (DEF) SWITCH
Positions the air outlet doors to the defrost position. Also positions the intake doors to the outside air position.
REAR WINDOW DEFOGGER SWITCH
When switch is ON, rear window is defogged.
OFF SWITCH
The compressor and blower are OFF, the intake doors are set to the outside air position, and the air outlet
doors are set to the foot (75% foot and 25% defrost) position.
A/C SWITCH
The compressor is ON or OFF.
(Pressing the A/C switch when the AUTO switch is ON will turn off the A/C switch and compressor.)
MODE SWITCH (FRONT)
Controls the air discharge outlets.
FRONT BLOWER CONTROL DIAL
Instructionly control the blower speed. Seven speeds are available for instruction control (as shown on the display
screen).
MODE SWITCH (REAR)
Controls the air/temperature at discharge outlets.
ATC-28
AIR CONDITIONER CONTROL
2005 Pathfinder
Rear Air Control
TEMPERATURE CONTROL DIAL (TEMPERATURE AND MODE CONTROL)
The temperature increases or decreases the set temperature. The mode also changes from foot at full hot set-
ting, to foot/vent at mid-range (warm) setting, and then to vent at full cold setting.
REAR BLOWER CONTROL DIAL
When the rear blower switch (front) is in the OFF position, the rear blower motor cannot operate.
When the rear blower switch (front) is in the REAR position, it allows the rear blower switch (rear) to control
the rear blower motor speed. In any other position (1-4), the rear blower switch (front) controls the rear blower
motor speed regardless of the rear blower switch (rear) position.
WJIA1042E
AIR CONDITIONER CONTROL
ATC-29
C
D
E
F
G
H
I
K
L
M
A
B
ATC
2005 Pathfinder
Discharge Air Flow
EJS002WP
FRONT
REAR
LJIA0172E
WJIA0528E
WJIA1076E
WJIA1236E
WJIA1236E
WJIA1236E
ATC-30
AIR CONDITIONER CONTROL
2005 Pathfinder
System Description (Front)
EJS002WQ
SWITCHES AND THEIR CONTROL FUNCTION
WJIA0584E
WJIA1237E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст