Nissan Pathfinder (2005 year). Instruction — part 232
MIL AND DATA LINK CONNECTOR
EC-707
C
D
E
F
G
H
I
J
K
L
M
A
EC
2005 Pathfinder
MIL AND DATA LINK CONNECTOR
PFP:24814
Wiring Diagram
UBS00KIY
BBWA1779E
EC-708
MIL AND DATA LINK CONNECTOR
2005 Pathfinder
BBWA1780E
SERVICE DATA AND SPECIFICATIONS (SDS)
EC-709
C
D
E
F
G
H
I
J
K
L
M
A
EC
2005 Pathfinder
SERVICE DATA AND SPECIFICATIONS (SDS)
PFP:00030
Fuel Pressure
UBS00KIZ
Idle Speed and Ignition Timing
UBS00KJ0
*: Under the following conditions:
●
Air conditioner switch: OFF
●
Electric load: OFF (Lights, heater fan & rear window defogger)
●
Steering wheel: Kept in straight-ahead position
Calculated Load Value
UBS00KJ1
Mass Air Flow Sensor
UBS00KJ2
*: Engine is warmed up to normal operating temperature and running under no-load.
Intake Air Temperature Sensor
UBS00KJ3
Engine Coolant Temperature Sensor
UBS00KJ4
Air Fuel Ratio (A/F) Sensor 1 Heater
UBS00KJ5
Heated Oxygen sensor 2 Heater
UBS00KJ6
Crankshaft Position Sensor (POS)
UBS00KJ7
Refer to
EC-304, "Component Inspection"
.
Camshaft Position Sensor (PHASE)
UBS00KJ8
Refer to
EC-313, "Component Inspection"
.
Throttle Control Motor
UBS00KJ9
Fuel pressure at idling kPa (kg/cm
2
, psi)
Approximately 350 (3.57, 51)
Target idle speed
No-load* (in P or N position)
625
±
50 rpm
Air conditioner: ON
In P or N position
775 rpm or more
Ignition timing
In P or N position
15
° ±
5
°
BTDC
Condition
Calculated load value% (Using CONSULT-II or GST)
At idle
5 - 35
At 2,500 rpm
5 - 35
Supply voltage
Battery voltage (11 - 14V)
Output voltage at idle
0.9 - 1.2*V
Mass air flow (Using CONSULT-II or GST)
2.0 - 6.0 g·m/sec at idle*
7.0 - 20.0 g·m/sec at 2,500 rpm*
Temperature
°
C (
°
F)
Resistance k
Ω
25 (77)
1.94 - 2.06
80 (176)
0.295 - 0.349
Temperature
°
C (
°
F)
Resistance k
Ω
20 (68)
2.1 - 2.9
50 (122)
0.68 - 1.00
90 (194)
0.236 - 0.260
Resistance [at 25
°
C (77
°
F)]
2.3 - 4.3
Ω
Resistance [at 25
°
C (77
°
F)]
9.9 - 13.3
Ω
Resistance [at 25
°
C (77
°
F)]
Approximately 1 - 15
Ω
EC-710
SERVICE DATA AND SPECIFICATIONS (SDS)
2005 Pathfinder
Injector
UBS00KJA
Fuel Pump
UBS00KJB
Resistance [at 10 - 60
°
C (50 - 140
°
F)]
11.1 - 14.5
Ω
Resistance [at 25
°
C (77
°
F)]
0.2 - 5.0
Ω
EI-1
EXTERIOR & INTERIOR
I BODY
CONTENTS
C
D
E
F
G
H
J
K
L
M
SECTION
A
B
EI
2005 Pathfinder
PRECAUTIONS . . . . . . . . . . . . . . .. 3
PREPARATION . . . . . . . . . . . . . . ... 4
Special Service Tools . . . . . . . . . . . ... 4
Commercial Service Tools . . . . . . . . . . 4
SQUEAK AND RATTLE TROUBLE DIAGNOSES. . 5
Work Flow . . . . . . . . . . . . . . . . 5
Generic Squeak and Rattle Troubleshooting . . ... 7
Diagnostic Worksheet . . . . . . . . . . . .. 9
CLIP AND FASTENER . . . . . . . . . . . ..11
Clip and Fastener . . . . . . . . . . . . . 11
FRONT BUMPER . . . . . . . . . . . . . . 14
Removal and Installation . . . . . . . . . . 14
REMOVAL . . . . . . . . . . . . . . ... 14
INSTALLATION . . . . . . . . . . . . ... 14
REAR BUMPER . . . . . . . . . . . . . ... 15
Removal and Installation . . . . . . . . . . 15
REMOVAL . . . . . . . . . . . . . . ... 15
INSTALLATION . . . . . . . . . . . . ... 15
FRONT GRILLE . . . . . . . . . . . . . . 16
Removal and Installation . . . . . . . . . . 16
REMOVAL . . . . . . . . . . . . . . ... 16
INSTALLATION . . . . . . . . . . . . ... 16
COWL TOP . . . . . . . . . . . . . . . ... 17
Removal and Installation . . . . . . . . . . 17
REMOVAL . . . . . . . . . . . . . . ... 17
INSTALLATION . . . . . . . . . . . . ... 17
FRONT FENDER . . . . . . . . . . . . . .. 18
Removal and Installation . . . . . . . . . . 18
REMOVAL . . . . . . . . . . . . . . ... 18
INSTALLATION . . . . . . . . . . . . ... 18
LICENSE LAMP FINISHER . . . . . . . . . .. 19
Removal and Installation . . . . . . . . . . 19
REMOVAL . . . . . . . . . . . . . . ... 19
INSTALLATION . . . . . . . . . . . . ... 19
FENDER PROTECTOR . . . . . . . . . . . 20
REMOVAL . . . . . . . . . . . . . . ... 21
INSTALLATION . . . . . . . . . . . . ... 21
Removal and Installation of Rear Fender Protector... 21
REMOVAL . . . . . . . . . . . . . . ... 21
INSTALLATION . . . . . . . . . . . . ... 21
RUNNING BOARDS . . . . . . . . . . . . . 22
Removal and Installation . . . . . . . . . . 22
REMOVAL . . . . . . . . . . . . . . ... 22
INSTALLATION . . . . . . . . . . . . ... 22
ROOF RACK . . . . . . . . . . . . . . . . 23
Removal and Installation . . . . . . . . . . 23
REMOVAL . . . . . . . . . . . . . . ... 23
INSTALLATION . . . . . . . . . . . . ... 23
DOOR OUTSIDE MOLDING . . . . . . . . . . 24
Removal and Installation . . . . . . . . . . 24
FRONT DOOR OUTSIDE MOLDING . . . . .. 24
DOOR FINISHER . . . . . . . . . . . . . .. 25
Removal and Installation . . . . . . . . . . 25
FRONT DOOR . . . . . . . . . . . . . 25
REAR DOOR . . . . . . . . . . . . . ... 26
EI-2
2005 Pathfinder
Components . . . . . . . . . . . . . . ... 27
Removal and installation . . . . . . . . . . . 28
FLOOR TRIM . . . . . . . . . . . . . . . 29
Removal and Installation . . . . . . . . . . 29
REMOVAL . . . . . . . . . . . . . . ... 29
INSTALLATION . . . . . . . . . . . . . 29
HEADLINING . . . . . . . . . . . . . . . .30
Removal and Installation . . . . . . . . . . .30
REMOVAL . . . . . . . . . . . . . . . 30
INSTALLATION . . . . . . . . . . . . . 31
LUGGAGE FLOOR TRIM . . . . . . . . . . .32
Components . . . . . . . . . . . . . . . 32
Removal and Installation . . . . . . . . . . .34
REMOVAL . . . . . . . . . . . . . . . 34
INSTALLATION . . . . . . . . . . . . . 34
BACK DOOR TRIM . . . . . . . . . . . . ...35
Removal and Installation . . . . . . . . . . .35
REMOVAL . . . . . . . . . . . . . . . 35
INSTALLATION . . . . . . . . . . . . . 35
PRECAUTIONS
EI-3
C
D
E
F
G
H
J
K
L
M
A
B
EI
2005 Pathfinder
PRECAUTIONS
PFP:00001
Service Notice
EIS0043V
●
When removing or installing various parts, place a cloth or padding on the vehicle body to prevent
scratches.
●
Handle trim, molding, instruments, grille, etc. carefully during removing or installing. Be careful not to soil
or damage them.
●
Apply sealing compound where necessary when installing parts.
●
When applying sealing compound, be careful that the sealing compound does not protrude from parts.
●
When replacing any metal parts (for example body outer panel, members, etc.), be sure to take rust pre-
vention measures.
Precautions for Supplemental Restraint System (SRS) “AIR BAG” and “SEAT
BELT PRE-TENSIONER”
EIS0043W
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SRS and SB section of this Service Man-
ual.
WARNING:
●
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death
in the event of a collision which would result in air bag inflation, all maintenance must be per-
formed by an authorized NISSAN/INFINITI dealer.
●
Improper maintenance, including incorrect removal and installation of the SRS, can lead to per-
sonal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air
Bag Module, see the SRS section.
●
Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Instruction. SRS wiring harnesses can be identified by yellow and/or orange harnesses or
harness connectors.
EI-4
PREPARATION
2005 Pathfinder
PREPARATION
PFP:00002
Special Service Tools
EIS0043X
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tools
EIS0043Y
Tool number
(Kent-Moore No.)
Tool name
Description
—
(J-39570)
Chassis ear
Locating the noise
—
(J-43980)
NISSAN Squeak and Rattle kit
Repairing the cause of noise
SBT839
SBT840
(Kent-Moore No.)
Tool name
Description
(J-39565)
Engine ear
Locating the noise
SIIA0995E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст