Nissan Pathfinder (2005 year). Instruction — part 91
HOOD
BL-15
C
D
E
F
G
H
J
K
L
M
A
B
BL
2005 Pathfinder
Be careful not to bend the cable too much, keep the radius
100mm (3.94 in) or more.
2.
Make sure the cable is not offset from the grommet, and push
the grommet into the lower dash panel hole securely.
3.
Apply sealant to the grommet (at * mark) properly.
4.
Install the cable securely to the lock.
5.
Adjust the hood lock. Refer to
.
Hood Lock Control Inspection
EIS003XZ
CAUTION:
If the hood lock cable is bent or deformed, replace it.
1.
Make sure the secondary latch is properly engaged with the sec-
ondary striker with hood's own weight by dropping it from
approx. 200 mm (7.87 in) height.
2.
While operating the hood opener, carefully make sure the front
end of the hood is raised by approx. 20 mm (0.79 in). Also make
sure the hood opener returns to the original position.
3.
Check the hood lock lubrication condition. If necessary, apply
“body grease” to the points shown in the figure.
LIIA1698E
LIIA1699E
PIIA1086E
PIIA0176E
BL-16
POWER DOOR LOCK SYSTEM
2005 Pathfinder
POWER DOOR LOCK SYSTEM
PFP:24814
Component Parts and Harness Connector Location
EIS003Y0
WIIA0440E
POWER DOOR LOCK SYSTEM
BL-17
C
D
E
F
G
H
J
K
L
M
A
B
BL
2005 Pathfinder
System Description
EIS003Y1
Power is supplied at all times
●
through 50A fusible link (letter g, located in the fuse and fusible link box)
●
to BCM (body control module) terminal 70 and
●
through 10A fuse (No. 25, located in the fuse and fusible link box)
●
to key switch terminal 2
●
through 10A fuse [No. 18, located in the fuse block (J/B)]
●
to BCM terminal 57.
Ground is supplied to terminal 67 of BCM through body grounds M57, M61 and M79.
INPUT
With the key in the ignition key cylinder, power is supplied
●
through key switch terminal 1
●
to BCM terminal 37.
With front door LH open, ground is supplied
●
to BCM terminal 47
●
through front door switch LH terminal 2
●
through front door switch LH case ground.
With front door RH open, ground is supplied
●
to BCM terminal 12
●
through front door switch RH terminal 2
●
through front door switch RH case ground.
With rear door LH open, ground is supplied
●
to BCM terminal 48
●
through rear door switch LH terminal 2
●
through rear door switch LH case ground.
With rear door RH open, ground is supplied
●
to BCM terminal 13
●
through rear door switch RH terminal 2
●
through rear door switch RH case ground.
With back door open, ground is supplied
●
to BCM terminal 43
●
through back door switch terminal 3
●
through back door switch terminal 1
●
through body grounds D406 and D504.
With the key inserted in the key cylinder LH and turned to LOCK, ground is supplied
●
to BCM terminal 8
●
through front door lock assembly LH (key cylinder switch) terminal 5
●
through front door lock assembly LH (key cylinder switch) terminal 4
●
through body grounds M57, M61 and M79.
With the key inserted in the key cylinder LH and turned to UNLOCK, ground is supplied
●
to BCM terminal 7
●
through front door lock assembly LH (key cylinder switch) terminal 3
●
through front door key cylinder switch LH terminal 4
●
through body grounds M57, M61 and M79.
With the main power window and door lock/unlock switch pressed to LOCK, ground is supplied
●
to BCM terminal 45
●
through main power window and door lock/unlock switch terminal 10
●
through main power window and door lock/unlock switch terminal 14
BL-18
POWER DOOR LOCK SYSTEM
2005 Pathfinder
●
through body grounds M57, M61 and M79.
With the power window and door lock/unlock switch RH pressed to LOCK, ground is supplied
●
to BCM terminal 45
●
through power window and door lock/unlock switch RH terminal 1
●
through power window and door lock/unlock switch RH terminal 3
●
through body grounds M57, M61 and M79.
With the main power window and door lock/unlock switch pressed to UNLOCK, ground is supplied
●
to BCM terminal 46
●
through main power window and door lock/unlock switch terminal 11
●
through main power window and door lock/unlock switch terminal 14
●
through body grounds M57, M61 and M79.
With the power window and door lock/unlock switch RH pressed to UNLOCK, ground is supplied
●
to BCM terminal 46
●
through power window and door lock/unlock switch RH terminal 2
●
through power window and door lock/unlock switch RH terminal 3
●
through body grounds M57, M61 and M79.
OUTPUT
Unlock
Ground is supplied
●
to front door lock assembly LH (actuator) terminal 1, front door lock actuator RH terminal 2, rear door lock
actuator LH and RH terminal 2, back door lock actuator terminal 2 and fuel lid door lock actuator terminal
1
●
through BCM terminal 65.
FRONT DOOR LH AND FUEL LID
Power is supplied
●
to front door lock assembly LH (actuator) terminal 2 and
●
fuel lid door lock actuator terminal 2
●
through BCM terminal 59.
FRONT DOOR RH
Power is supplied
●
to front door lock actuator RH terminal 1
●
through BCM terminal 66.
REAR DOOR LH AND RH
Power is supplied
●
to rear door lock actuator LH and RH terminal 1
●
through BCM terminal 66.
BACK DOOR
Power is supplied
●
to back door lock actuator terminal 2
●
through BCM terminal 66.
With power and ground applied as described, the doors and fuel lid are unlocked.
Lock
Ground is supplied
●
to front door lock assembly LH (actuator) and fuel lid door lock actuator terminal 2
●
through BCM terminal 59 and
●
to front door lock actuator RH terminal 1, rear door lock actuator LH and RH terminal 1 and back door lock
actuator terminal 2
●
through BCM terminal 66.
Power is supplied
●
to front door lock assembly LH (actuator) terminal 1
POWER DOOR LOCK SYSTEM
BL-19
C
D
E
F
G
H
J
K
L
M
A
B
BL
2005 Pathfinder
●
fuel lid door lock actuator terminal 1
●
front door lock actuator RH terminal 2
●
rear door lock actuator LH and RH terminal 2
●
back door lock actuator terminal 4
●
through BCM terminal 65.
With power and ground applied as described, the doors and fuel lid are locked.
OPERATION
●
The main power window and door lock/unlock switch on front door LH trim and door lock/unlock switch
RH on front door RH trim can lock and unlock all doors.
●
With the key inserted in the front door key cylinder LH, turning it to LOCK locks all doors; turning it to
UNLOCK once unlocks the front door LH and fuel lid; turning it to UNLOCK again within 5 seconds of the
first unlock operation unlocks all other doors [signal from door key cylinder switch (part of front door lock
assembly LH)].
Key Reminder
When performing a door locking operation using either the main power window and door lock/unlock switch or
the power window and door lock/unlock switch RH, all the doors will lock and then will immediately unlock if
●
the key switch is in INSERTED position (key is in ignition key cylinder) and
●
the ignition switch is in the OFF position and
●
any door is open.
BL-20
POWER DOOR LOCK SYSTEM
2005 Pathfinder
Schematic
EIS003Y2
WIWA0537E
POWER DOOR LOCK SYSTEM
BL-21
C
D
E
F
G
H
J
K
L
M
A
B
BL
2005 Pathfinder
Wiring Diagram — D/LOCK —
EIS003Y3
WIWA0538E
BL-22
POWER DOOR LOCK SYSTEM
2005 Pathfinder
WIWA0539E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст