Nissan X-Trail 32. Instruction — part 713
SERVICE DATA AND SPECIFICATIONS (SDS)
DLN-263
< SERVICE DATA AND SPECIFICATIONS (SDS)
[REAR FINAL DRIVE: R145]
C
E
F
G
H
I
J
K
L
M
A
B
DLN
N
O
P
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
General Specifications
INFOID:0000000011008634
Preload Torque
INFOID:0000000011008635
Unit: N·m (kg-m, in-lb)
Drive Gear Runout
INFOID:0000000011008636
Unit: mm (in)
Backlash
INFOID:0000000011008637
Unit: mm (in)
Differential Side Gear Clearance
INFOID:0000000011008638
Unit: mm (in)
Applied model
Axle
4WD
Engine
MR20DD
QR25DE
R9M
Transaxle
CVT
M/T
Final drive model
R145
Gear ratio
2.466
Number of teeth (Drive gear/Drive pinion)
37/15
Number of pinion gears
2
Drive pinion adjustment spacer type
Collapsible
Oil capacity
Refer to
MA-23, "Fluids and Lubricants"
Item
Standard
Pinion bearing (P
1
)
0.69 – 1.18 (0.07 – 0.12, 7 – 10)
Side bearing (P
2
)
0.66 – 1.00 (0.07 – 0.10, 6 – 8)
Side bearing to pinion bearing (Total preload)
(Total preload = P
1
+ P
2
)
1.35 – 2.18 (0.14 – 0.22, 12 – 19)
Item
Standard
Drive gear back face runout
0.05 (0.0020) or less
Item
Standard
Drive gear to drive pinion gear
0.10 – 0.15 (0.0039 – 0.0059)
Item
Standard
Side gear backlash (Clearance between side gear and differential
case)
0.10 (0.004) or less
(Each gear should rotate smoothly without excessive resistance
during differential motion.)
DMS-1
CRUISE CONTROL & DRIVER ASSISTANCE
C
D
E
F
G
H
I
J
K
L
M
B
DMS
SECTION
DMS
N
P
A
CONTENTS
DRIVE MODE SYSTEM
ECO MODE
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
Precautions for Removing Battery Terminal . . .....
SYSTEM DESCRIPTION . . . . . . . ..
COMPONENT PARTS . . . . . . . . . .
Component Parts Location . . . . . . . . . ....
ECO Mode Switch . . . . . . . . . . . . .....
SYSTEM . . . . . . . . . . . . . . . ..
ECO MODE CONTROL . . . . . . . . . . . ...
ECO MODE CONTROL : System Description . . ..
ECO MODE CONTROL : Circuit Diagram . . . ....
INFORMATION DISPLAY (COMBINATION
METER) . . . . . . . . . . . . . . . . . ...
INFORMATION DISPLAY (COMBINATION
METER) : ECO Mode Indicator . . . . . . . .....
WARNING/INDICATOR/CHIME LIST . . . . . .....
WARNING/INDICATOR/CHIME LIST : Warning/
Indicator (On Information Display) . . . . . . ....
ECU DIAGNOSIS INFORMATION . . . ..
ECO MODE . . . . . . . . . . . . . .
List of ECU Reference . . . . . . . . . . . .
WIRING DIAGRAM . . . . . . . . . ..
ECO MODE SYSTEM . . . . . . . . . ...
Wiring Diagram . . . . . . . . . . . . . .
BASIC INSPECTION . . . . . . . . ...
DIAGNOSIS AND REPAIR WORK FLOW . ...
Work Flow . . . . . . . . . . . . . . . .
DTC/CIRCUIT DIAGNOSIS . . . . . . .
ECO MODE SWITCH . . . . . . . . . .
Component Function Check . . . . . . . . .
Diagnosis Procedure . . . . . . . . . . . ...
Component Inspection . . . . . . . . . . . .
SYMPTOM DIAGNOSIS . . . . . . . ..
THE ECO MODE INDICATOR DOES NOT
TURN ON . . . . . . . . . . . . . . ..
Description . . . . . . . . . . . . . . . ...
Diagnosis Procedure . . . . . . . . . . . ...
REMOVAL AND INSTALLATION . . . ...
ECO MODE SWITCH . . . . . . . . . .
DMS-2
< PRECAUTION >
[ECO MODE]
PRECAUTIONS
PRECAUTION
PRECAUTIONS
Precautions for Removing Battery Terminal
INFOID:0000000011010012
• With the adoption of Auto ACC function, ACC power is automatically supplied by operating the intelligent key
or remote keyless entry or by opening/closing the driver side door. In addition, ACC power is supplied even
after the ignition switch is turned to the OFF position, i.e. ACC power is supplied for a certain fixed time.
• When disconnecting the 12V battery terminal, turn off the ACC
power before disconnecting the 12V battery terminal, observing
“How to disconnect 12V battery terminal” described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignition
switch is turned OFF and ignition power supply is stopped. If the
battery terminal is disconnected before ECU stops, accidental DTC
detection or ECU data damage may occur.
• For vehicles with the 2-batteries, be sure to connect the main bat-
tery and the sub battery before turning ON the ignition switch.
NOTE:
If the ignition switch is turned ON with any one of the terminals of
main battery and sub battery disconnected, then DTC may be detected.
• After installing the 12V battery, always check "Self Diagnosis Result" of all ECUs and erase DTC.
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to Instruction 1 or Instruction 2 described below.
For vehicles parked by ignition switch OFF, refer to Instruction 2.
INSTRUCTION 1
1.
Open the hood.
2.
Turn key switch to the OFF position with the driver side door opened.
3.
Get out of the vehicle and close the driver side door.
4.
Wait at least 3 minutes. For vehicle with the engine listed below, remove the battery terminal after a lapse
of the specified time.
CAUTION:
While waiting, never operate the vehicle such as locking, opening, and closing doors. Violation of
this caution results in the activation of ACC power supply according to the Auto ACC function.
5.
Remove 12V battery terminal.
CAUTION:
After installing 12V battery, always check self-diagnosis results of all ECUs and erase DTC.
INSTRUCTION 2 (FOR VEHICLES PARKED BY IGNITION SWITCH OFF)
1.
Unlock the door with intelligent key or remote keyless entry.
NOTE:
At this moment, ACC power is supplied.
2.
Open the driver side door.
3.
Open the hood.
4.
Close the driver side door.
5.
Wait at least 3 minutes.
SEF289H
D4D engine
: 20 minutes
HRA2DDT
: 12 minutes
K9K engine
: 4 minutes
M9R engine
: 4 minutes
R9M engine
: 4 minutes
V9X engine
: 4 minutes
DMS
PRECAUTIONS
DMS-3
< PRECAUTION >
[ECO MODE]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
CAUTION:
While waiting, never operate the vehicle such as locking, opening, and closing doors. Violation of
this caution results in the activation of ACC power supply according to the Auto ACC function.
6.
Remove 12V battery terminal.
CAUTION:
After installing 12V battery, always check self-diagnosis results of all ECUs and erase DTC.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст