Nissan X-Trail 32. Instruction — part 1817
SYSTEM
SEC-35
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
BCM INPUT/OUTPUT SIGNAL CHART
Input Signal Item
Output Signal Item
SYSTEM DESCRIPTION
• The system reduces the possibility of a theft or mischief by sounding siren and blinking hazard warning lamp
continuously. The system activates siren and hazard warning lamp when detecting that the door or hood is
opened, or there is an illegal attempt to enter into the passenger room, while the system is in the ARMED
phase.
• Security indicator lamp on combination meter always blinks when ignition switch is any position other than
ON to warn that the vehicle is equipped with a VEHICLE SECURITY SYSTEM.
• Anti-theft function is improved by the adoption of intruder sensor that detects an attempt to enter into the
passenger room.
• Activation or deactivation of intruder sensor can be selected by sensor cancel switch.
• Siren control unit equips a built-in battery. Replace siren control unit once every 10 years because the war-
ranty for built-in battery expires after 10 years.
• Each time the system switches to the PRE-ARMED phase from the DISARMED phase, the self-diagnosis is
performed by the siren control unit and each sensor. If any malfunction is detected, the siren sounds* 5
times to inform the driver that a malfunction is detected and the vehicle security system does not function
properly. Malfunctioning part can be checked by “SIREN” in “ACTIVE TEST” mode of “THEFT ALM” of
“BCM” using CONSULT. Refer to
SEC-64, "Diagnosis Description"
.
*: Siren sounds for 0.2 seconds and sound interval is 0.4 seconds.
Operation Flow
Transmit unit
Signal name
IPDM E/R
CAN communication
Hood switch signal
Push-button ignition switch
Push switch signal
Each door switch
Door switch signal
Each door request switch
Door request switch signal
Siren control unit
Hazard warning signal
Sensor cancel switch
Sensor cancel switch signal
Reception unit
Signal name
Combination meter (security indicator lamp)
Security indicator lamp signal
Siren control unit
Alarm link signal
Hazard warning lamp
Hazard warning lamp signal
Outside key antenna
Outside key antenna signal
JMKIB3879GB
SEC-36
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
SYSTEM
No.
System state
Switching condition
DISARMED to
PRE-FULL
ARMED
When all conditions of A and
one condition of B is satis-
fied.
A
B
• Ignition switch: OFF
• All doors: Closed
• Hood: Closed
All doors are locked by:
• LOCK button of Intelligent Key
• Door request switch
DISARMED to
PRE-PARTIAL
ARMED
When all conditions of A and
one condition of B is satis-
fied.
A
B
• Ignition switch: OFF
• Hood or any door: Open
All doors are locked by:
• LOCK button of Intelligent Key
• Door request switch
PRE-FULL
ARMED to DIS-
ARMED
When one of the following
condition is satisfied.
• Ignition switch: ON
• UNLOCK button of Intelligent Key: ON
• Door request switch: ON
PRE-PARTIAL
ARMED to DIS-
ARMED
When one of the following
condition is satisfied.
• Ignition switch: ON
• UNLOCK button of Intelligent Key: ON
• Door request switch: ON
PRE-PARTIAL
ARMED to PRE-
FULL ARMED
When all of the following
conditions are satisfied.
• All doors: Closed
• Hood: Closed
PRE-FULL
ARMED to PRE-
PARTIAL ARMED
When one of the following
condition is satisfied.
• Any door: Opened
• Hood: Opened
PRE-FULL
ARMED to FULL
ARMED
When all of the following
conditions are satisfied for
20 seconds.
• Ignition switch: OFF
• All doors: Closed
• Hood: Closed
PRE-PARTIAL
ARMED to PAR-
TIAL ARMED
When all of the following
conditions are satisfied for
20 seconds.
• Ignition switch: OFF
• Hood or any door: Open
PARTIAL to FULL
ARMED
When all of the following
conditions are satisfied for
20 seconds.
• Ignition switch: OFF
• All doors: Closed
• Hood: Closed
FULL ARMED to
DISARMED
When one of the following
condition is satisfied.
• Ignition switch: ON
• UNLOCK button of Intelligent Key: ON
• Door request switch: ON
PARTIAL ARMED
to DISARM
FULL ARMED to
ALARM
When one of the following
condition is detected.
• Any door or hood is opened
• Battery connection is disconnected
• Movement to enter into passenger room
• Communication between BCM and siren control unit is interrupted
• Communication between siren control unit and intruder sensor is in-
terrupted
PARTIAL ARMED
to ALARM
When one of the following
condition is detected.
• Any door or hood is opened
• Battery connection is disconnected
• Communication between BCM and siren control unit is interrupted
• Communication between siren control unit and intruder sensor is in-
terrupted
ALARM to
DISARMED
When one of the following
condition is satisfied.
• Ignition switch: ON
• UNLOCK button of Intelligent Key: ON
• Door request switch: ON
ALARM to ALARM
PAUSE
27.5 seconds are passed.
ARM PAUSE to
FULL ARMED
5 seconds are passed after deactivating ALARM.
ARM PAUSE to
PARTIAL ARMED
SYSTEM
SEC-37
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
NOTE:
To lock/unlock all doors by operating remote controller button of Intelligent Key or door request switch, Intelligent Key must be within the
detection area of outside key antenna. For details, refer to
DLK-42, "DOOR LOCK FUNCTION : System Description"
(Type1) or
352, "DOOR LOCK FUNCTION : System Description"
(Type2).
Disarmed Phase
VEHICLE SECURITY SYSTEM switches to the DISARMED phase while any doors or hood is open because it
is assumed that the owner is in or nearby the vehicle.
Pre-armed Phase
• VEHICLE SECURITY SYSTEM switches to the PRE-ARMED phase and blinks security indicator lamp
quickly for approximately 20 seconds when all doors are locked by Intelligent Key or door request switch,
while all doors and hood are closed.
• VEHICLE SECURITY SYSTEM that is in the PRE-ARMED phase switches to the DISARMED phase when
all doors are unlocked by Intelligent Key or door request switch or ignition switch is switched to the ON posi-
tion.
• VEHICLE SECURITY SYSTEM does not activate siren when door or hood is open while VEHICLE SECU-
RITY SYSTEM is in the PRE-ARMED phase. When the door or hood is closed again, VEHICLE SECURITY
SYSTEM stays in the PRE-ARMED phase.
Armed Phase
VEHICLE SECURITY SYSTEM switches to the ARMED phase from the PRE-ARMED phase after approxi-
mately 20 seconds, and blinks security indicator lamp slowly.
Alarm Phase
• VEHICLE SECURITY SYSTEM activates siren for approximately 27.5 seconds when any of the following
conditions is fulfilled while VEHICLE SECURITY SYSTEM is in the ARMED phase.
- When any door or hood is open
- When intruder sensor detects an attempt to enter into passenger compartment
- When battery connection is disconnected
- Communication between BCM and siren control unit is interrupted
- Communication between siren control unit and intruder sensor is interrupted
• VEHICLE SECURITY SYSTEM deactivates siren when door is unlocked by Intelligent Key or door request
switch, or the ignition switch is switched to the ON position while siren is activated.
• VEHICLE SECURITY SYSTEM switches to the ARMED phase automatically when approximately 5 sec-
onds pass after deactivating siren.
SENSOR CANCEL FUNCTION
Perform the following procedure to deactivate intruder sensor.
1.
CHECK SENSOR CANCEL FUNCTION
1.
Turn ignition switch OFF.
2.
Press sensor cancel switch, and before 5 minutes pass, close all doors and hood, and lock all doors using
the Intelligent Key or door request switch.
3.
Check that VEHICLE SECURY SYSTEM is switched to the PRE-ARMED phase and that the siren sounds
one beep.
NOTE:
Intruder sensor is not cancelled and return to normal operation when any of the following conditions is fulfilled
while the cancellation procedure is being performed.
• When ignition switch turns ON.
• When 5 minutes or more pass after pressing sensor cancel switch.
• When VEHICLE SECURITY SYSTEM switches to the DISARMED phase.
Does security indicator lamp blink quickly?
YES
>> INSPECTION END
NO
>> Check again.
ALARM PAUSE to
DISARMED
When one of the following
condition is satisfied.
• Ignition switch: ON
• UNLOCK button of Intelligent Key: ON
• Door request switch: ON
No.
System state
Switching condition
SEC-38
< SYSTEM DESCRIPTION >
[WITH INTELLIGENT KEY SYSTEM]
SYSTEM
VEHICLE SECURITY SYSTEM : Circuit Diagram
INFOID:0000000010947196
JMKIB3743GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст