Nissan X-Trail 32. Instruction — part 1765
RF-46
< REMOVAL AND INSTALLATION >
GLASS LID
REMOVAL AND INSTALLATION
GLASS LID
Exploded View
INFOID:0000000010735426
Front sunroof bracket RH
Glass lid
Wind deflector
Rear sunroof bracket RH
Side trim RH
Sunroof unit assembly
Front drain hose RH
Sunroof motor assembly
Front drain connector RH
Harness connector assembly
Front drain connector LH
Sunshade motor assembly
JMKIB2824GB
GLASS LID
RF-47
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
Removal and Installation
INFOID:0000000010735427
REMOVAL
CAUTION:
Always work with a helper.
1.
Remove side trim (LH/RH).
2.
Remove glass lid fixing screws
, and then remove glass lid.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
After installing the glass lid, perform the leak test and check that there is no malfunction.
NOTE:
After installation, carry out fitting adjustment. Refer to
.
Adjustment
INFOID:0000000010735428
If the clearance and the surface height are out of specification, adjust them according to the procedures
shown below.
Front drain hose LH
Side trim LH
Rear sunroof bracket LH
Sunshade
Rear drain connector LH
Rear drain hose LH
Rear drain hose RH
Rear drain connector RH
Front sunroof bracket LH
Rear sunroof glass
Drain assembly
: Clip
: N·m (kg-m, in-lb)
,
,
,
,
,
,
,
,
,
: Indicates that the part is connected at points with same symbol in actual vehicle.
JMKIB2807ZZ
JMKIB2827GB
Roof panel
Glass lid
Rear sunroof glass
RF-48
< REMOVAL AND INSTALLATION >
GLASS LID
NOTE:
Dimension (B) is given assuming that the glass upper side status is (+), and the glass lower side status is (
−
)
relative to the roof panel.
1.
Loosen glass lid mounting fixing screws.
2.
Adjust the clearance of glass lid and roof panel according to the fitting standard dimension.
3.
To prevent glass lid from moving after adjustment, first tighten the fixing screws of front left, and then
tighten the screws of rear right.
4.
Tilt glass lid up and down several times to check that it moves smoothly.
NOTE:
After adjustment the sunroof unit assembly, perform additional service. Refer to
Portion
A
B
−
6.5 – 8.1 mm
(0.256 – 0.319 in)
(
−
2.2) – (+0.8) mm
[(
−
0.087) – (+0.031) in]
−
6.5 – 8.1 mm
(0.256 – 0.319 in)
(
−
2.2) – (+0.8) mm
[(
−
0.087) – (+0.031) in]
−
6.5 – 8.1 mm
(0.256 – 0.319 in)
(
−
1.5) – (+1.5) mm
[(
−
0.059) – (+0.059) in]
REAR SUNROOF GLASS
RF-49
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
REAR SUNROOF GLASS
Exploded View
INFOID:0000000010735429
Front sunroof bracket RH
Glass lid
Wind deflector
Rear sunroof bracket RH
Side trim RH
Sunroof unit assembly
Front drain hose RH
Sunroof motor assembly
Front drain connector RH
Harness connector assembly
Front drain connector LH
Sunshade motor assembly
Front drain hose LH
Side trim LH
Rear sunroof bracket LH
Sunshade
Rear drain connector LH
Rear drain hose LH
JMKIB2824GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст