Nissan X-Trail 32. Instruction — part 2008
STR-32
< REMOVAL AND INSTALLATION >
STARTER MOTOR
DISASSEMBLY
Converter housing
“S” terminal harness
“B” terminal harness
Starter motor
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
JMBIA4494GB
STARTER MOTOR
STR-33
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
M
A
STR
N
P
O
S114-961
JMBIA4495GB
Magnetic switch assembly
Adjusting plate
Dust cover
Shift lever set
Pinion stopper clip
Pinion stopper
Pinion
Pinion spring
Gear case assembly
Center bracket (A)
Yoke assembly
Armature assembly
Brush holder assembly
Thrust washer
Rear cover
Internal gear
Planetary gear
Pinion shaft
Packing
Thrust washer
Center gear assembly
Thrust washer
E-ring
Clutch gear assembly
: High-temperature grease point
STR-34
< REMOVAL AND INSTALLATION >
STARTER MOTOR
M000TB0071
QR25DE : Removal and Installation
INFOID:0000000010728724
REMOVAL
1.
Remove battery. Refer to
PG-142, "EXCEPT FOR R9M : Removal and Installation"
2.
Remove air duct. Refer to
EM-175, "Removal and Installation"
3.
Disconnect ECM harness connectors
.
JSBIA4204GB
Magnetic switch assembly
Dust cover kit
Gear case assembly
Pinion assembly
Stopper
Ring
Ring
Stopper
Yoke assembly
Armature assembly
Brush holder assembly
Metal
Rear cover
Gear assembly
Shift lever set
Clutch gear assembly
Center bracket
Gear shaft
: N·m (kg-m, in-lb)
: Vehicle front
JMBIA4626ZZ
STARTER MOTOR
STR-35
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
M
A
STR
N
P
O
4.
Remove TCM bracket mounting bolts
.
5.
Remove harness fixing clip
.
6.
Remove battery tray mounting bolts
, and then remove battery
tray .
7.
Remove harness bracket mounting bolts
and harness fixing
clip .
8.
Remove harness bracket
.
9.
Remove “B” terminal nut and “B” terminal harness.
10. Remove “S” terminal nut and “S” terminal harness.
11. Remove starter motor mounting bolts.
12. Remove starter motor upward from the vehicle.
INSTALLATION
Note the following item, and then install in the reverse order of removal.
CAUTION:
Be careful to tighten “B” terminal nut to the specified torque.
QR25DE : Inspection
INFOID:0000000010728725
MAGNETIC SWITCH
• Before starting to check, disconnect the battery cable from the negative terminal.
• Disconnect “M” terminal of starter motor.
1.
Continuity test (between “S” terminal and switch body)
• Replace magnetic switch if continuity does not exist.
: Vehicle front
JMBIA4627ZZ
: Vehicle front
JMBIA4628ZZ
: “S” terminal
: “B” terminal
: “M” terminal
SKIB9002E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст