Nissan X-Trail 32. Instruction — part 220
REPLACEMENT OPERATIONS
BRM-41
< REMOVAL AND INSTALLATION >
[FOR EUROPE (LHD)]
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
Urethane foam
Body sealing
Unit: mm (in)
: Vehicle front
: Drill
φ
6 mm (0.24 in) hole for the plug welding hole (ultra high strength steel).
: Drill
φ
8 mm (0.31 in) hole for the plug welding hole (ultra high strength steel).
: Weld the parts onto the back of the component part.
Replacement part
z
Side body assembly
z
Upper inner front pillar
z
Side dash
JSKIA4920GB
BRM-42
< REMOVAL AND INSTALLATION >
[FOR EUROPE (LHD)]
REPLACEMENT OPERATIONS
View D: Before installing side body assembly
View F: Before installing outer front side body
Unit: mm (in)
: Vehicle front
: Drill
φ
6 mm (0.24 in) hole for the plug welding hole (ultra high strength steel).
: Drill
φ
7 mm (0.28 in) hole for the plug welding hole (ultra high strength steel).
: Drill
φ
9 mm (0.35 in) hole for the plug welding hole (ultra high strength steel).
: Weld the parts onto the back of the component part.
: For spot welding of steel plate of tensile strength 980 MPa, observe the indicated welding conditions. Refer to
ing of Ultra High Strength Steel"
JSKIA4921GB
REPLACEMENT OPERATIONS
BRM-43
< REMOVAL AND INSTALLATION >
[FOR EUROPE (LHD)]
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
View H and J: Before installing side body assembly
View O: Before installing outer front side body
Unit: mm (in)
: Vehicle front
: Drill
φ
6 mm (0.24 in) hole for the plug welding hole (ultra high strength steel).
: Drill
φ
7 mm (0.28 in) hole for the plug welding hole (ultra high strength steel).
: Drill
φ
10 mm (0.39 in) hole for the plug welding hole (ultra high strength steel).
: Weld the parts onto the back of the component part.
: N·m (kg-m, ft-lb)
JSKIA4922GB
BRM-44
< REMOVAL AND INSTALLATION >
[FOR EUROPE (LHD)]
REPLACEMENT OPERATIONS
Center Pillar
INFOID:0000000010843436
Unit: mm (in)
: Vehicle front
: Drill
φ
6 mm (0.24 in) hole for the plug welding hole (ultra high strength steel).
: Drill
φ
7 mm (0.28 in) hole for the plug welding hole (ultra high strength steel).
: Drill
φ
9 mm (0.35 in) hole for the plug welding hole (ultra high strength steel).
: Weld the parts onto the back of the component part.
: For spot welding of steel plate of tensile strength 980 MPa, observe the indicated welding conditions. Refer to
ing of Ultra High Strength Steel"
JSKIA4608GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст