Nissan X-Trail 32. Instruction — part 614
SYSTEM
DLK-797
< SYSTEM DESCRIPTION >
[TYPE 4]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
SYSTEM
POWER DOOR LOCK SYSTEM
POWER DOOR LOCK SYSTEM : System Description
INFOID:0000000010755009
SYSTEM DIAGRAM
DOOR LOCK FUNCTION
Door Lock and Unlock Switch
• The door lock and unlock switch is built into power window main switch.
• Interlocked with the locking operation of door lock and unlock switch, door lock actuator of all doors are
locked.
• Interlocked with the unlocking operation of door lock and unlock switch, door lock actuator of all doors are
unlocked.
Unlock Sensor
• BCM locks all doors or unlocks all doors, when driver door lock knob is operated.
• With the mechanical key inserted in the door key cylinder on driver side, turning it to lock position, locks door
lock actuator of all doors.
• With the mechanical key inserted in the door key cylinder on driver side, turning it to unlock position once
unlocks the driver door, turning it to unlock position again within 5 seconds after the first unlock operation
unlocks all of the other doors actuator. (Anti-hijack function operation)
Anti-hijack function operation mode can be changed using CONSULT. Refer to
CONSULT Function (BCM - DOOR LOCK) (Without Intelligent Key System and Super Lock)"
Operation Condition
If all of the following conditions are satisfied, door lock and unlock operation is performed using the door lock
and unlock switch.
KEY REMINDER FUNCTION
• While ignition key is inserted in ignition key cylinder and driver door is open, door is not locked when door
lock and unlock switch is pressed in the lock direction. This prevents keyfob from being left in the vehicle.
• While door lock and unlock switch is pressed in the lock direction, combination meter buzzer sounds and
warns.
INTERIOR ROOM LAMP CONTROL FUNCTION
Interior room lamp is controlled according to door lock/unlock state, refer to
CONTROL SYSTEM : System Description"
OVERRIDE FUNCTION
JMKIB3733GB
Door lock and unlock switch operation
Operation condition
LOCK/UNLOCK
• Doors are not locked by keyfob and auto door lock function
• Ignition position warning function is not activated
DLK-798
< SYSTEM DESCRIPTION >
[TYPE 4]
SYSTEM
When inside handle of driver door is operated while doors are in lock states, lock state of the applicable door
lock becomes invalid and the door is open.
UNLOCK LINK FUNCTION
When driver door is opened using the override function, all doors are unlocked.
Unlock function operates when driver door is open while all of the following conditions are satisfied.
NOTE:
When anti-hijack function is activated, only the applicable door is unlocked.
Operation condition
• Doors are locked by door lock/unlock switch or by automatic lock/unlock function
• Driver side door switch is switched from OFF to ON
• Anti-hijack function is not activated
• Vehicle speed is 5 km/h (3 MPH) or less
SYSTEM
DLK-799
< SYSTEM DESCRIPTION >
[TYPE 4]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
POWER DOOR LOCK SYSTEM : Circuit Diagram
INFOID:0000000010755010
REMOTE KEYLESS ENTRY SYSTEM
JMKIB3734GB
DLK-800
< SYSTEM DESCRIPTION >
[TYPE 4]
SYSTEM
REMOTE KEYLESS ENTRY SYSTEM : System Description
INFOID:0000000010755011
System Diagram
DOOR LOCK AND UNLOCK OPERATION
• When door lock and unlock button of keyfob is pressed, door lock and unlock signal transmits from keyfob to
BCM via remote keyless entry receiver.
• When BCM receives the door lock and unlock signal, it operates door lock actuator, brinks the hazard lamp
at the same time as a reminder.
OPERATION CONDITION
If the following conditions are satisfied, door lock/unlock operation is performed if the keyfob is operated.
OPERATION AREA
To ensure that the keyfob works effectively, use within 1 m (3 ft) range of each door, however the operable
range may differ according to surroundings.
ANTI-HIJACK FUNCTION
• When an LOCK signal is transmitted from keyfob, all doors are locked.
• When an UNLOCK signal is transmitted from keyfob once, driver side door is unlocked.
• Then, if an UNLOCK signal is transmitted from keyfob again, all other doors are unlocked.
How to change anti-hijack mode.
With CONSULT
Anti-hijack mode can be set to ON or OFF using CONSULT.
Refer to
DLK-808, "DOOR LOCK : CONSULT Function (BCM - DOOR LOCK) (Without Intelligent Key System
Without CONSULT
• ON/OFF can be switched when keyfob lock button and unlock button are pressed simultaneously for 5 sec-
onds or more while steering lock is locked.
• When mode is switched, hazard warning lamp blinks.
REMINDER FUNCTION
Operation Description
When doors are locked or unlocked by keyfob button operation, BCM blinks hazard warning lamps as a
reminder.
JMKIB3697GB
Remote controller operation
Operation condition
Lock
• Key switch is off
• All doors are closed
Unlock
Key switch is off
OFF
→
ON
: 1 blinks
ON
→
OFF
: 3 blink
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст