Nissan X-Trail 32. Instruction — part 1334
GW-54
< REMOVAL AND INSTALLATION >
REAR DOOR GLASS
9.
Disengage rear door lower sash from open part of rear door panel as shown by the arrow in the figure.
10. Remove rear door lower sash from open part of rear door panel as shown by the arrow in the figure.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
• Make sure that rear door lower sash and rear door sash (door
panel side) are engaged.
• Tighten rear door lower sash mounting bolts to the specified torque. Refer to
REAR DOOR CORNER PIECE
REAR DOOR CORNER PIECE : Removal and Installation
INFOID:0000000010755119
REMOVAL
CAUTION:
Never damage rear door glass and rear door panel.
1.
Remove rear door lower sash. Refer to
GW-52, "REAR DOOR LOWER SASH : Removal and Installa-
2.
Fully open rear door glass.
JMKIB3166ZZ
JMKIB3167ZZ
JMKIB3142ZZ
REAR DOOR GLASS
GW-55
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
GW
N
O
P
3.
Turn over rear door weather-strip
, and then remove rear door corner piece fixing screws
.
4.
Remove rear door corner piece from rear door panel according
to numerical order 1
→
2 as shown by the arrow in the figure.
INSTALLATION
Note the following item, and then install in the reverse order of removal.
CAUTION:
Tighten rear door corner piece fixing screws the specified torque. Refer to
REAR DOOR GLASS RUN
REAR DOOR GLASS RUN : Removal and Installation
INFOID:0000000010755120
REMOVAL
CAUTION:
Never excessively pull rear door glass run.
1.
Remove rear door glass. Refer to
GW-51, "REAR DOOR GLASS : Removal and Installation"
.
2.
Remove rear door glass run from rear door panel.
CAUTION:
Rear door glass run should be pulled out slowly.
INSTALLATION
Note the following item, and then install in the reverse order of removal.
CAUTION:
Make sure that rear door glass run are engaged to rear door lower sash and rear door sash (door panel
side).
JMKIB3169ZZ
JMKIB3170ZZ
JMKIB3172ZZ
GW-56
< REMOVAL AND INSTALLATION >
REAR DOOR GLASS
Inspection and Adjustment
INFOID:0000000010755121
FITTING INSPECTION
• Check that the glass is fit securely into the sash groove.
• Lower the glass slightly [approximately 10 to 20 mm (0.394 to 0.787 in)], and check that the clearance to the
sash is parallel. Loosen the regulator mounting bolts, guide rail mounting bolts, and glass and guide rail
mounting bolts to correct the glass position if the clearance between the glass and sash is not parallel.
REAR DOOR REGULATOR
GW-57
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
GW
N
O
P
REAR DOOR REGULATOR
Exploded View
INFOID:0000000010755122
RHD models
Removal and Installation
INFOID:0000000010755123
REMOVAL
CAUTION:
Never damage rear door glass and rear door panel.
1.
Remove rear door glass. Refer to
GW-51, "REAR DOOR GLASS : Removal and Installation"
.
JMKIB3200GB
Rear door glass run
Rear door panel
Rear door sealing screen
Rear door regulator
Rear door power window motor
Rear door glass
Rear door lower sash
Rear door corner piece
: N·m (kg-m, in-lb)
,
,
,
,
,
,
,
,
,
: Indicates that the part is connected at points with same symbol in actual vehicle.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст